Vinyl soffit corners! Easy!

No video

Vinyl soffit corners! Easy!

Рет қаралды 18,157

Күн бұрын

This video shows a way to miter your vinyl soffit even with no “H” channel. The contractor we’re doing this job for did not send any, so we had to improvise. Lots more to come, and videos WILL get better! Thanks for watching!!

Пікірлер: 26

@walkerbranson4497 8 ай бұрын

Thanks for the video. Definity helps those who are learning. Keep up the good work friend.

@shandoe7gw867 3 жыл бұрын

I like it! I will be doing this on my house. Thanks and be careful on those ladder jacks lol

@raymondcompton6290 4 жыл бұрын

I'm not sure if you want it to look that way on a 45 miter. I simply make a 90 degree cut then bend it in on itself so the face of the f (or j-chanel) just has an overlap. (much the same as j-channel on a gable peak). Bonus look would be to take your knife and slice off the inside of the hem for a tighter outside miter. This would be acceptable if the exterior is getting brick as it would be hidden but for a normal outside corner the gap would show.

@terrymcgillicuddy8056 4 жыл бұрын

Thanks for the video 👍

@michaelsherron7815 9 ай бұрын

Best video I've seen so far, I gotta install this, for the first time tomorrow and I got butterflies on how to do the corners. Can I send photos to you to look at? Thanks.

@Debtfreehomesteaders 4 жыл бұрын

Clean! -Will

@Phoenixrising8313 2 жыл бұрын

Hammer is way too big for siding and metal work lol.

@buckethead1928 2 жыл бұрын

Not if you know how to use it.

@Phoenixrising8313 2 жыл бұрын

@@buckethead1928 Didn't you hit and break the j channel?

@buckethead1928 2 жыл бұрын

@@Phoenixrising8313 lol I did hit it but it didn’t break. And I seen that after I replied to your comment 😂

@joechase1713 4 жыл бұрын

So.... How many times did you have to hit those nails to drive them in? Seriously, I'm glad I'm not working ouside in these cold months anymore... You Youngsters can have at it ... LMAO

@buckethead1928 4 жыл бұрын

Lol I know that was terrible, didn’t want to hit the F again hahahaha

@candygirl8881 3 жыл бұрын

This is not the way to do that

@greglawrence742 Жыл бұрын

It'd be a great look with the cutout angle reduced so the final gap was closed up. Loved the concept, the guys.

@vballjim01 4 жыл бұрын

Helpful video, but you could set a better example for safety. No guard on your grinder, no eye or ear protection.

@buckethead1928 4 жыл бұрын

You’re right, thanks for the comment!

@vin4301 3 жыл бұрын

Real men don't need safety

@vballjim01 3 жыл бұрын

@@vin4301How would you know? Did you ask one?

@greglawrence742 Жыл бұрын

The safety sqint and selective hearing are a close second to glasses and ear plugs.

@steveseger5642 8 күн бұрын

Most workers dont put a guard on their grinder. It gets in the way. Professional grinder cutters like me know how to use the grinder safely without guards.