Dnt forget to subscribe and hit the like button we are almost at 1k subscribers thanks
@DarioMelkuhnАй бұрын
Thanks for this, had problems with mine giving me ETS light and loosing cruise control. We changed the sensor but could not see where that O ring went. This is the only video I could find that shows where it goes. Hence we had an ABS failure. Thank you
@fredaydaybae84503 жыл бұрын
Thanks!! Got two Volvo S80’s and they’ve BOTH got this code. Gna fix this soon.
@WhipCityWrencher4 жыл бұрын
Good Job! 👍
@routinedrop4692 Жыл бұрын
I found a decent one on IPD for mine also wanna note that my 05 xc90 had a different connector
@routinedrop4692 Жыл бұрын
Oh and also didn't have to remove the brace in order to extract it
@jklfdssss Жыл бұрын
Thank you!
@WrenchingMafia Жыл бұрын
Thank you
@gotredeemed Жыл бұрын
Nice job!
@djkasdjkasdjdjdj3 ай бұрын
is there a side effect for other components if I let this device fails like never gonna change it?
@WrenchingMafia3 ай бұрын
Does this car have an electronic vacuum pump
@djkasdjkasdjdjdj3 ай бұрын
@@WrenchingMafia its a 2004 S60, im not sure what vacuum pump it has 😅
@WrenchingMafia3 ай бұрын
@djkasdjkasdjdjdj I would still replace it just to clear check engine light
@djkasdjkasdjdjdj3 ай бұрын
@@WrenchingMafia i see
@fridaymwamba95102 жыл бұрын
hi, thanks for the video. what machine are you using here? i see it has volvo specific codes.
@douglaswallace7765 Жыл бұрын
Loved your video but wd40 deteriorates rubber I thought so maybe just some grease or vaseline would be best using on it u think . Or am I wrong
@tannerjackson53504 ай бұрын
Do I need to clear codes after this install?
@WrenchingMafia4 ай бұрын
Yes you will need to clear codes
@tannerjackson53504 ай бұрын
@@WrenchingMafia I have code p0573 (brake switch circuit a high) that shows up on a cheaper code reader I used a more expensive reading and 9400 came up. I already replaced the Brake Switch that did nothing to help. So I’m replacing the Brake Pedal Sensor. I don’t have full-time access to the nicer reader that displays code 9400.
@ygkremer Жыл бұрын
Do you maybe still have a part number? The ebay link is down. Thank you for the vid! I thought it would be much more difficult.
@WrenchingMafia Жыл бұрын
I do not sorry I’ll give you the part number in a bit
@christiancook68863 жыл бұрын
Is this part of the cruise control /brake sensor. On this vehicle or just pedal sensor
@WrenchingMafia3 жыл бұрын
It’s also for cruse control if this goes bad the cruise control function will not work
@dannetornqvist9194 Жыл бұрын
Hello A question about a v70n 01! Drove a v70n before and had stopped to have a bite, when we were going to leave, started the car as usual but nothing happened when I stepped on the gas pedal?! Turned the car off and restarted to no avail! Troubleshoot with a fault code reader and got code ECM 9400 Acelation pos sensor break pedal sensor! Reset this and now the car runs as usual! Got info about sensor, sensor for the brake pedal that sits next to the brake fluid holder! Also got a message engine system service immediately in the info box when this happened! Sincerely
@WrenchingMafia Жыл бұрын
Yea that will fix it
@dannetornqvist9194 Жыл бұрын
@@WrenchingMafia Thanks
@Precisiongoat Жыл бұрын
Does the brake sensor keep the brake lights on
@WrenchingMafia Жыл бұрын
Yes that sensor would be located by the brake pedal inside the car
@WrenchingMafia Жыл бұрын
Thanks for watching dnt forget to subscribe
@Precisiongoat Жыл бұрын
That’s the switch. My Volvo keeps the lights on …. But its not the brake switch So idk what it is The lights wont turn boff