Volvo IPS Drive Assembly and Installation

Рет қаралды 23,255

FHG Marine Engineering

3 жыл бұрын

Volvo IPS drive removed for some repair work, re-assembled and installed on the vessel

Пікірлер: 8

@keithtam20cd 3 жыл бұрын

i love the video so much!

@fhgmarineengineering139 3 жыл бұрын

Glad you enjoyed it!

@michaelbgentry 3 жыл бұрын

great video, thanks for sharing.

@shawnwood9875 3 жыл бұрын

Was this preventive maintenance? I understand all PODS need this done but just checking to see if this normal preventive.

@V8burble 3 жыл бұрын

It’s a difficult one isn’t it.... efficiency and obvious boat handling benefits of IPS over less complicated shaft drives. Does the fuel savings and benefits outweigh the additional services costs? Just how long do these generally last before a strip down if properly maintained with oil changes and regular cleaning?

@YSALF 2 жыл бұрын

6 month later…but I would like to see the pending answer too

@Smokeyr67 2 жыл бұрын

The costs (for second + Gen IPS drives) aren’t really that much more than a shaft driven boat, you just need to take her out of the water every year or so (same as any water berthed boat) for a hull clean, then you replace the oil (there’s a lot of that, 20 odd litres) the anodes and inspect, it’s really not a great deal more than shafts or stern drive. Where the costs come is in repairs, if you need to replace bearings or seals it can be a bit expensive, but with the new units that’s a once a decade issue if you keep up the annual maintenance.