It’s all smoke and mirrors. Really I know fuck all useful.

@@StupidBlokeStupidVideos i was just biggin you up bruvva to all those new subscribers.........🤣🤣

@@bettyourcampervan does he have any subscribers that he doesn't know personally?

@@sally6457 🤣🤣

It is good innit, I show it in this video. This cars got/had a few issues recently. We’ve got the shitter running ok now and will be getting a good oil flush soon hopefully This is the headlight removal you was talking about 🤣 kzfaq.info/get/bejne/ecVjoLFims3MZqc.html

@@StupidBlokeStupidVideos as per previous , if ts had dilution it wont need a flush lol once an injectors leaking at one end , odds on its not right at the other ,,, bit like a dodgy curry , both ends at once , ,,, no extra flushing required . yep the hand grenade system ,,, pull the pin and hope for the result you wish for.

The injector leaking back can definitely cause your issue so I’d definitely agree that changing it should sort the problem. As long as it isn’t seized in, then it’s a nice easy job.

I've just replaced injector no 1 as it was badly leaking. On the scanner its dose was about 5.4 here other 4 are very close to 0 (- 0.01 to 0.05) Ive installed and coded a brand new (not rebuild) bosh injector. It is a massive improvement! It has a dose of 0.03 so very similar to other onea in my engine. Engine starts a lot softer and faster than before. Many thanks for the video. It helped in my issue as I was blaming the rail.

Just happened to my d5 v70 I was thinking my fuel pump had gone but am hoping it’s just a injector now, I put my foot down for a split second and engine service system required came up then next couple mile later car lost power and shut off and wouldn’t turn back on but will crank over

@@M1.942 stop safely on the hard shoulder. Take the fob out of the slot and put it back on. It will start then. After that tour automatic gearbox will need some time to start to wark. Mine locked on the first gear for about a minute. I have noticed that you need to rev the engine to the rpm's when it lost power. After that it will start shifting. Good lick with your issue

@@M1.942 have you tried a bit of brake cleaner to see if that gets it started? I’d advise doing a leak off test to see if any injectors are leaking back excessively

Thanks mate 🤣

YES

Sorry about that. The foot tap is probably the only good thing in most of my videos tbh 😂

The ecu will figure it out after a few miles and adjust the fuel trim to compensate.

Nah. You should really do it as it’s a calibration code, but these will usually sort themselves out without it. The one in the vid still hasn’t been coded in yet I don’t think 😂

It’s all one piece if I remember right. The inlet manifold is part of the rocker cover

@@StupidBlokeStupidVideos thx

Hi mate. These are commonrail so as long as there’s no major issues it should self prime. Not all commonrail systems do but most do as long as they have a lift pump. I’m pretty sure these ones are in the tank. Also, thanks mate

Thank you! Mine is a common rail injector but I don't know what that mean.

@@BlueSky-bx5tf I mean the system should be self priming. The reason I changed this injector was because it was throwing the fuel back to the tank from the leak off too fast for the hp pump to keep up on cranking, so it wouldn’t build pressure enough to reach the threshold to open on the injectors and run. It would fire up if you gave it a sniff of easy start though. Could be worth a go in your case to get it going but be sparing with it

I was thinking too, to pray in some starter fluid. Where would I have to spray it in, in the air cleaner box? After I replaced the valve cover gasket, the motor doesn't start anymore.

@@BlueSky-bx5tf yea in the air filter box should be fine. Only a little squirt as if there’s no fuel at the pump and it runs too long it will kill the pump. You could try cracking an injector to see if fuel is there first. Where I spray the turbo cleaner in this video could be better built at filter box be fine kzfaq.info/get/bejne/nLhngrt7t6nZnYE.htmlsi=XjYu6IELcK3ettYt

Removes the injector out of the head, and installs it into the forehead.

@@StupidBlokeStupidVideos Your reply has me cracking up 🤣 Into the forehead🤣🤣

@@StupidBlokeStupidVideos might knock a bit of sense into you? 🤔

Sorry, I’ll try to do better in future 😞

Any plans to show the coding?

Fuck it, not my car 🤷‍♀️

@@StupidBlokeStupidVideos 😂😂😂👍

Leek’n!?

Something like that 🤔