VW Touran 2008 rear door panel removal window not going up and down but motor is working

Рет қаралды 34,931

3 жыл бұрын

Пікірлер: 24

@Escapee5931 2 жыл бұрын

Thanks for the help DB. I stuck a piece of gaffer tape at the back of the glass carrier (over the hole) to stop the plastic pins pushing all the way through. Worked quite well.

@DaringBeefcake 2 жыл бұрын

You welcome, and thanks for the tip that’s a good idea, I’ll use that in future :)

@robertmawanda 2 жыл бұрын

Thanks alot for this helpful video. My VW window just behaved the same way. I know I will fix it following these instructions.

@DaringBeefcake 2 жыл бұрын

Glad it helped :)

@kinspired9416 3 жыл бұрын

Thank you for sharing. I had exactly this problem. I watched your video and did the same fix - excellent!

@DaringBeefcake 3 жыл бұрын

oh thank you am really happy to hear that.

@krasimirgedzhov8942 Жыл бұрын

Thank you sir, for your video. We have the same problem in our Touran, and I'll try this fix as soon as possible. Frustrating little plastic pin! :) Something so small opening up so much work!

@DaringBeefcake Жыл бұрын

You welcome 🙏 yes that little pin is a pain no the greatest of designs there.

@mralpay8961 7 күн бұрын

@@DaringBeefcake hello this little pin what is the name ?

@DaringBeefcake 5 күн бұрын

@@mralpay8961 am not sure, if you google Vw door window pin retainer you might get some results.

@Co074K4t5 2 жыл бұрын

Very informative and what a great accent 👍

@DaringBeefcake 2 жыл бұрын

Glad you think so!

@gaellestephan7522 9 ай бұрын

Thank you for this vidéo 👌👌 il had exactly the same problem 😇😇😇

@DaringBeefcake 9 ай бұрын

You're welcome 😊

@mralpay8961 9 ай бұрын

Hello! @DaringBeefcake we dot this but panel not comming down

@DaringBeefcake 9 ай бұрын

You have to push the panel up a bit and release it from the bottom first then it should como out a little. Is not going to come out all the way unless you drill the rivets.

@yahiaasfari6504 3 жыл бұрын

Good job

@DaringBeefcake 3 жыл бұрын

Thank you 😊

@aboaymanhimmich6569 Жыл бұрын

Thanks a lot

@DaringBeefcake Жыл бұрын

You are very welcome 🙏

@Mr.JOHNY5ka 2 жыл бұрын

The procedure for inserting the pin is wrong. The pin must be inserted into the window and then lowered into the holder (it has tapers for the pin).

@DaringBeefcake 2 жыл бұрын

Oh ok, well may be others can apply that way of doing it, thanks for the message...

@scott4wrestlingv2 Жыл бұрын

If I was to drill the rivets out do I need to replace them or can I get away without?

@DaringBeefcake Жыл бұрын

not really, as the whole thing is one unit sort of thing so your window will mechanism will either get damage or rattle a lot every time you open or close the window...