That evap looks real nice. Guessing the original one was leaking from the coil and got replaced. I would have thrown a peanut on this one. We back in the low 30s in Michigan. LOL.

"Summer time has finally arrived" lol back in the 50s, low 60s for high.

Sounds like a Monday call

So here's an old school rule we usta use, this is so old I'm taking r12, r22, r502 stuff and it always worked with condenser fan cycling switches. What ever pressure corresponded with 105' F you set the switch to close at 25# over, and open at 5# under. Fan cycling causes head pressure to swing up and down, not good for can compressors. Gives them a short life. That compressor your working on looks like an old Copeland semihermetic. Those things were nearly bullet proof . I've seen those flipped upside down on a roof from the wind and were still running and maintaining temp.

❄️💪🇺🇸👍 tough times in restaurant biz. Maybe just swap out fcs b4 fall /winter. 404a is a blend n they can show bubbles n during low load conditions.

Anytime there’s a hot box a load on the box the sight glass will flash until that temp comes down to around 45 degrees

All this Waygu talk has me wanting a steak.😀

wago connectors do pop apart sometimes. have had issues with them

good job. I enjoyed the diagnostic. That is a crusty old B. hopefully they will upgrade soon.

I have a call back on wego connector

Wouldn't the efficiently be greater at night with a lower temp liquid?

Wagyu nuts are for effete technicians. I am an effete tech.

Put an ICM fan speed controller on it. Much better than off/on. Nothing is as good as a headmaster though. Just a thought.

Give it 15 mins or so

How do you like that adjustable wrench? I’ve seen them but hesitant to buy them.

🤘🙌