TRAXXAS VXL 3351R BRUSHLESS MOTOR AND BEARING CLEANING | #VXL #NOPREP 3351R - Motor, Velineon® 3500, brushless (assembled with 12-gauge wire and gold-plated bullet connectors)
Пікірлер: 23
@itzzgraham Жыл бұрын
Thank you so much man I went to use my slash today and it didn’t wanna roll, the first thing I did was takeoff my pinion gear, thinking something in my transmission grenaded but it rolled freely. Then I plug the battery in a notice that my mother was making a squealing sound! Same motor and when you give it throttle, it would only spin for half of a second before stopping it was all binded up, I took off the motor, cover under the screws and took off the first plate and clean the bearing and everything very well and moved the motor up and down and it freed all the dirt it’s working perfectly again
@UDRC85 Жыл бұрын
That’s awesome. I am so glad this helped you. 👊🏾
@karlfortuin57949 ай бұрын
I have that motor in my bandit & yes I run it on 3s & the lipo I'm running it on is the ho vo & yes it litterly makes my bandit rip!!!
@CainSample2 жыл бұрын
Very cool👍 I have alot of these and never opened one up or had a problem with any of the newer ones...I'm afraid to look at mine lol I'm sure they need it
@UDRC852 жыл бұрын
Lol. You would be amazed what you can find. If you remove the stock bearings and put ceramic bearings in the motor you can gain some et and mph.
@CainSample2 жыл бұрын
@@UDRC85 yeah I'm not looking lol I guarantee mine are nasty lol...I can deff see the ceramic ones Makin a diff...you gonna do that?
@UDRC852 жыл бұрын
@@CainSample 🤣👊🏾
@mikebianco7854 Жыл бұрын
Great video
@bobaque702 жыл бұрын
Brush technique the best
@UDRC852 жыл бұрын
Yes sir. I get the for free too 🤣
@kenmaxson937110 ай бұрын
should replace the bearing
@CoachD3862 жыл бұрын
👍🏾💯
@UDRC852 жыл бұрын
Appreciate that.
@williamquick61539 ай бұрын
One plastic shim is supposed to go on the pinion side of the rotor and the other goes on the cap side before that brass bushing
@brianu3311 ай бұрын
Arrma 3s let’s in a ton of dirt. My bearing in motor exploded. The can and armature are very dirty. Is it safe to spray contact cleaner on it and in motor can to clean it out? I’ve read a few people said yes and a couple said no. ? Thank you in advance. I was also thinking of blocking unused motor holes to keep dirt out and under motor where rocks and dirt get in.
@phillybrc2 жыл бұрын
i m gonna do this,thanx
@UDRC852 жыл бұрын
Yes, a must. Free up some hp 🤣
@TheAnimatedPixels Жыл бұрын
Where can I get a replacement for the wires?
@shaikrafee9336 Жыл бұрын
And Esc how much Amps??
@dougkreutz77012 жыл бұрын
Should have reoiled your bearings while apart.
@UDRC852 жыл бұрын
Appreciate the information. Yes I oiled it later on.