Nice bro

Zberdast kareger.excellent.... Aysy karuger dubhai men hon to so malamal krden

I have been working in Fabrication of Bowsers / Tanks and Trailers, The King Pin is the Key Component between Prime Mover and the Trailer / Tanker. I Being Mechanical Design Engineer worked on Design Calculations, Sizing of King Pin and Preparation of Shop Drawings; location Point of King Pin (Fifth Wheel) on both the Truck and Trailer was also Calculated. The Craftsman has good Command over Machining and making of King Pin without any Drawing, his Skill is appreciable, The Old Shaft Material from Scrap would be definitely the Carbon Steel, should have been Tested before use.

That tail stock has seen better days it has a case of the wobbles

The milling machine reminds me of a small version of a machine I worked at Napa Pipe( Kaiser steel think was the old name)

Congrats bro,,, Your channel is successful 😉👌

Nice one bro

Техника безопасности? Не, не знаю!!!

💘 P R O M O S M.