WE P99 | God of War | PX001 Disassembly + Tips & Tricks (Full Tutorial)

Рет қаралды 1,263

Жыл бұрын

Full teardown and reassembly of the We-Tech P99, plus some tips and general advice.
Checkout our socials!
Shop: www.eastcoastcustomblasters.com/
Instagram: / eastcoastcustomblasters
Facebook: / eastcoastcustomblasters
Linktree: linktr.ee/EastCoastCustomBlas...

Пікірлер: 10

@pauloram2563 11 ай бұрын

Love your videos love the p99 great stuff👍

@AdamHoy81 Жыл бұрын

Excellent vid mate, mine is still running strong, keep up the great work 👍

@-_Nuke_- 3 ай бұрын

18:34 Hammer out 26:49 Hammer dissasembly 31:52 Hammer assembly 47:02 Hammer insert When you assemble the hammer there are 2 screws on the Hammer itself (plust a small one on the top). If you have a hard time putting the hammer back into the gun, make sure you haven't squeezed the screws too hard, like I was doing and took me 4 hours to figure it out :/ You can screw it harder after you have inserted the hammer in the gun. Later.

@michaelbowron8379 Жыл бұрын

Done well and might be getting one of those soon bro

@Danny-G Жыл бұрын

They are really nice :)

@-_Nuke_- 3 ай бұрын

Hello! I want to buy a flashlight for it but I don't know which one I should buy... Any ideas?

@Ionlycomeoutatnight 10 ай бұрын

My hammer has dropped down. Literally pulling the trigger and getting no response. It's lost its connection

@Danny-G 10 ай бұрын

do you mean hammer is cocked and pulling trigger does nothing? Could be sear or trigger bar is damaged. Do you run green gas or co2??

@Ionlycomeoutatnight 10 ай бұрын

@@Danny-G basically, I've taken the slide off and if the hammer has been clocked the trigger just goes back without firing the hammer. There's no clicking of it when fired. The hammer going back but nothing from there. I use green gas. But wasn't actively using it on a game. I had it out at home and when taken off its safety, it felt a little odd. Then nothing from it

@Danny-G 10 ай бұрын

@@Ionlycomeoutatnight If the hammer locks back, it means hammer is fine it is probably an issue with the sear or trigger bar. The trigger bar is meant to be raised by the spring that holds it to the chassis, try holding the trigger bar upwards as you push the trigger with the slide off and see if that engages the sear . It is very similar to an M9 if you are familiar with them. Check that the spring on the trigger bar isn't damaged.