What is a Chiller Economizer
Рет қаралды 3,730
Күн бұрынI explain what a economizer is on a chiller. These components are used to improve efficiency by increasing subcooling and in some cases removing the flash gas.
Chiller Training at chilleracademy.com
Troubleshooting Guides at hvactime.shop
TruTech Tools Promo: HVACTIME
@Eighty8Fitter 3 ай бұрын
Refrigeration racks use subcoolers quite often. Improving efficiency is the overall name of the game.
@kc5vgw 23 күн бұрын
On the Trane cvhe and cvhf, the economizer does not pull into the suction. It is pulling into either the inlet of the second stage wheel, or 3rd wheel. Depending on if it’s a cvhe or f. On the york screws, the economizer is ported about 1.3 or 1.4x of suction. No appreciable loss as you can introduce more gas after the suction portion without adding any more load to the motor.
@Ingmaringmar 3 ай бұрын
In screw compressors the subcooler is connected to the eco port of te compressor, with a different (higher) pressure than suction pressure. (This is where the efficiency gain is). How is that for centrifugal compressors?
@kc5vgw 23 күн бұрын
Same with a centrifugal, provided it has more than 1 stage. York yt and yk, as well as yz and YMC2 are only 1 stage of compression. However Trane uses multiple stages. And the york OM’s are multistage. Between 2 and 5 stages. Only seen 5 stage in the refineries. Usually for the PDU. Propane de asphalting unit. And they are almost always R-290 systems
@HVACGUY 3 ай бұрын
Gree flexx hs those before liquid line to add subcooling.
@isaiahlewis3832 2 ай бұрын
What’s making the vapor rise to the top of the flash tank ?
@HVACTIME 2 ай бұрын
Vapor is less dense than liquid. Vapor rises on top and the liquid collects in the bottom.
@isaiahlewis3832 2 ай бұрын
The condenser is sending liquid refrigerant to the flash tank how is that liquid being turned into a gas ? & does it has something to do with pressurization or expansion and how ?
@HVACTIME 2 ай бұрын
Through a expansion valve. There is a expansion valve prior to the flash tank that creates the flash gas.
@isaiahlewis3832 2 ай бұрын
Thank you so much & when u say create the flash gas that means changing the state correct ?
@HVACTIME 2 ай бұрын
@isaiahlewis3832 correct, charging state
@Skunkhunt_42 25 күн бұрын
Yes @@isaiahlewis3832
@irfvnfaedah5776 3 ай бұрын
Sr ,may u help me, on york yciv Is there the High pressure cut out at system 1 is serial with system 3 on logic board
@kc5vgw 23 күн бұрын
Yes. I think it’s due to a limitation of the digital inputs on the boards.
@NROhvac 3 ай бұрын
Is it ok to think chiller economisers are similar to hot gas bypass, by the concept of keeping a load on the chiller?
@HVACTIME 3 ай бұрын
No, different concept
@NROhvac 3 ай бұрын
@@HVACTIME ok I understand thank you
Just Have a Think
Рет қаралды 393 М.
Eater Straw Hat
Рет қаралды 26 МЛН
Subcool HVAC
Рет қаралды 10 М.
Zebra Learnings
Рет қаралды 92 М.