Get your vehicle insured online here 👇
ACKO CAR INSURANCE
bit.ly/3xR7tFG
When an engine produces power and clutch and transmission convert it into required torque, some assembly is needed to carry this torque to driving axle or usually to rear axle. This assembly is known as drive line. A drive line consist one or more drive shaft (propeller shaft), universal joints, and slip joints.
Various types of propeller shaft, universal joint, and slip joints are used to carry engine power from the transmission box to the driving wheels. Today I am going to tell you about drive shaft component and there working in detail.
These are the main components of drive shaft-
What is Drive Line? What are Main Component of Drive Line? (propeller shaft)
Propeller shaft:
The propeller shaft is a driving shaft which connects the transmission main shaft to the differential of the real axle. It transmits the power from gear box to rear axle with the help of universal joints. The propeller shaft is also known as drive shaft. It performs the following function:
To receive the power from the gear box output shaft and without any change in speed transmit it to the input pinion of the differential for onward transmission to the rear axle and rear wheels.
To cope with the difference in line with the level of the gear box output shaft and the differential input pinion shaft.
The propeller shaft has to operate at varied lengths and varied angles. The engine of the automobile is somewhat rigidly attached to the frame by springs. As the vehicle moves on the road there are jerks and bumps due to which the springs expand and contract. This changes the angle of drive between the propeller shaft and the transmission shaft. The distance between the gear box and differential also changes due to the movement of the springs. So the propeller shaft has to meet both the angular change coming between the gear box and differential and change in length of the distance between the gear box and differential. The propeller shaft is also not on the same line as the gear box output shaft but it runs to the rear axle at an angle because the level of the rear axle is lower than the gear box. So to adjust angular motion universal joints are provided and to adjust for the change in length of the propeller shaft , a slip joint is provided.
The propeller shaft has to withstand the torsional stresses of the transmitting torque, and yet it must be light and well balanced so that vibrations will not occur at high speed. So it is usually made of a strong steel tube.
Universal joint:
A universal joint allows driving torque to be carried through two shafts that are at an angle with each other. A simple universal joint consist two Y- shaped yoke, one on the driving shaft and other on the driven shaft. The four arms of spider are assembled in needle bearings in the two yokes. The driving shaft and yoke force the spider to rotate. The other two trunnions of the spider then cause the driven yoke to rotate. When the two shafts are at an angle with each other, the needle bearings permit the yokes to swing around on the trunnions with each revolution. A simple universal joint does not transmit the motion uniformly when the shafts are operating an angle. Because of this, two universal joints are used in a vehicle, one between the gear box and the propeller shaft and other between the propeller shaft and the differential pinion shaft.
What is Drive Line? What are Main Component of Drive Line? (universal joint)
Slip joint:
Slip joint is attached to the driven yoke in order the increase or decrease the length of propeller shaft. It has outside splines on the shaft and matching internal splines in a mating hollow shaft or yoke. When assembled the splines cause the shafts to rotate together while they can move back and forth. This changes the length of propeller shaft.