You’re the only person on KZfaq that made this video so thank you

guys, those with chewed-up, bent, frayed, broken cables, visit your nearest bicycle shop you can buy a bare cable as a cheap replacement, it is used for mechanical brakes on bicycles, mountain bikes. and long enough so you can cut to original length, insert cable to the original tubings and pathways before crimping the end-tips on the motor spool side, you can also buy those end-tips of the cable just crimp with pliers. no special tools needed just a bit of patience required.

Duuuuude! I've been at this for four fing hours. Then I watched your video and BAM!!!! Thank youuuuuuuuu!!!!

Thank you, i thought i was screwed when my replacement unravelled itself. Good guide.

Great video. Thanks!! Had to tear into the door to replace a broken driver's side exterior door handle on a 2011 Mazda CX 7. The regulator cables unspooled when I removed the regulator motor. Found it impossible to get the spool back into the housing after rewinding the two cables due to the two springs on the cable ends. Having another set of hands to compress the springs (as you show here...) when snapping the rewound spring back in was necessary into order to get enough cable slack to get the spool back into the housing.

audio would make it interesting.!!!

Just seeing you put the spool on last helped me. It was hard to find help for this repair. Thanks!

Right on man! Thank you. I watched lots of videos and yours was the one that helped me!

great video really helped me out i was about to mess up my cables and it took a while but finally found a video

Thanks bro saved me from a headache love KZfaq!!

Bro I need audio. Your video is the best describe one but no audio

Thank you i took the motor off of a 2018 kia optima regulator to roll down the window manually the wire popped out and the deadline for the car was a week ago. I could not take this to the front office without them getting pissed.

The 2010 Hyundai Elantra uses a nearly identical reel design and there are 2 flaws to it: 1. Both the "UP" and "DOWN" cables use the same reel, so if either gets off-track, they'll rub. 2. There is nearly no guide on the reel itself to keep the cable from falling between the reel and the housing, so as the front and back surfaces of the reel wear, it becomes easier for the cable to fall between the reel and the housing, causing a big tangle. Seems like kind of a crap design, but a lot of carmakers use it. I'm putting mine back together with 50 LB fishing line, which is smaller and might stay away from the edges, but I'm not expecting it to last the ages.

Your the man excellent video … mashed my head that Gt continentel

I am sure its a good video, but without any sound we wikll newver know.

just did this on my moms mazda 3......what a shit show..

Unfortunately my tool box didn't come with the 4 hands required to assemble this four lettered feat of human engineering.

same thing, bro thanks!

wish that was easy for me my pully thing snapped and the wire around the pulley is frayed wire :(

thanks dude...same here I was replacing one when the new one unraveled itself ...

Wouod be nice if you spoke abit just a plain video sucks I'm still not able to do it

Window register driver side parts kits for 2001 Chevy Silverado

thank you so much for this video

F**KING FINALLY!!! You are the real MVP!

Kia optimas regulator is practically one piece with the whole panel behind the door

so u need 2 people

Not sure how to do it with only one person

i can literally count the pixels

Lifesaver 😅😭

Ooooh that’s how that works, whoops 😅

?

DAMN. I wish i had 4 hands and better lighting