One day woodworking projects MagSafe charging stand for iPhone
I used walnut and linden wood, tung oil + carnauba wax finish. The insides are a wireless charging module and small neodymium magnets 1.5 mm thick, but it seemed to me that it would be better to take magnets 2 mm thick. I messed up a little at the beginning of the video with the polarity of the magnets, then I had to redo it - peel off the magnets and turn them over and take them out to a larger radius, since at the first location of the magnets the phone did not charge and the board and the coil got very hot. In general, the story is this, I wanted to buy a good and beautiful stand with MagSafe charging for my iPhone and I didn’t find something I liked on the Internet, then I looked for ideas on Pinterest, but I didn’t find anything interesting there, and it happened this is a stand. In my opinion, it turned out very simply, modestly, but at the same time quite elegantly and...🙂 I hope you like it and want to make yourself the same :) Thank you all very much, respectfully Yurii, greetings from Odessa, Ukraine.
Thanks to those who support me and my channel on paypal PayPal : romyrwood@gmail.com
Thanks for watching, Regards Yurii🤗🇺🇦
For a wonderful hammer made of titanium and stainless steel, as well as a planer knife made of titanium and incredible steel, many thanks to Luke from Zen Woo Tools - zenwutoolworks.com/products/
The music in the video is taken from Epidemic sound share.epidemicsound.com/0aywse