Thanks, I'm glad you enjoyed it.

Thanks! About an hour or two is usually good for wooden molds. Plastic molds maybe a bit longer. Rotate by 90 degrees after 20 minutes or so to avoid creases on the side. That said, I've left cigars in their mold anywhere from 10 minutes up to maybe a month (forgot them in the mold) and they turned out fine.

@@CatharsisCigars Nice!! I am planning on getting a mold and some leaf online. Probably watch one of your videos over and over then give it the good ole drop-out-of-college and find a real job try!

@@bonelessrocker Hey brother, as a new roller myself, you might want to hold off on the molds until you have some cigars under your belt. Getting the bunching correctly the same on every cigar is very difficult. If you look into paper molding it works on any size you end up rolling and costs virtually nothing. Good luck, it's a lot of fun and very rewarding in the end.

@@MB-zj3er Thanks for the heads up! I ordered some leaf online from "Leaf only" hoping it is here soon, Lol. As well as some leafs for cigars I have some Perique coming for my pipe as well! I will let you know how it goes.

@@bonelessrocker You are very welcome, please do come back and let me know how you make out. Did you order a kit? I have ordered two from Whole Leaf but they sell smaller kits than Leaf Only. I have purchased 2 one pound kits and gotten 40 cigars including a couple of Cuban Sandwiches from the scraps. The hardest part has been getting the tightness of the roll right for a proper draw, but it only means I get to smoke more cigars experimenting. I think I hit it right around #6. I was trying to roll them too tightly. Also if they are a little loose you can always tighten them with the paper molding after testing the draw. Better too loose than too tight in my experience so far.