Plasma cutting countersunk bolt holes with the Koike 3DLT bevel head and Mastergraph EX2 using X-Definition XPR300 by Hypertherm. Also available on the Versagraph Extreme, CNC cutting machine for larger plate formats.
Пікірлер: 21
@awfab3517 Жыл бұрын
Looks cleaner and sharper than laser
@rmkensington6 ай бұрын
On thicker materials it always is
@phillhuddleston94453 жыл бұрын
Cool but beyond my budget right now.
@michaelangelo80012 жыл бұрын
Impressive...
@slamurai8080 Жыл бұрын
how good is the quality when cutting stainless steel?
@shanedunne721010 ай бұрын
What cut chart do you use to obtain required bevel cuts please?
@dittagecoeco27385 жыл бұрын
Wonderful tech
@photonashville4 жыл бұрын
Plasma cutting dance club remix.
@jackzhang72324 жыл бұрын
Like the cutting effect with using Oxygen or Air? what gas did your machine be use in XPR300?
@KoikeAronsonRansome4 жыл бұрын
They used Oxygen and Air as this is mild steel
@jackzhang72324 жыл бұрын
@@KoikeAronsonRansome for your beveling, you use Hypertherm system or your own system? And beveling device of Lifting up and down---Hypertherm or your own developing and researching ? Thanks!
@amarendranathpuhan96976 жыл бұрын
GREAT
@asistenteadministrativanem17102 жыл бұрын
Donde puedo conseguir esa maquina ?
@KoikeAronsonRansome Жыл бұрын
www.koike.com/mastergraph-ex2
@chrisc1886 жыл бұрын
What gases were used for the bevels? Is it possible to cut the holes with the bevelled side to the bottom? Carbide overlay plate requires cutting with the carbide down and the large end of the bevel must be on the carbide side.
@shanedunne721010 ай бұрын
I always cut carbide with carbide facing upwards
@chrisc18810 ай бұрын
@@shanedunne7210 You're contaminating the base plate by doing so. Any welding done on the base will require a grind prep to remove contamination before applying a weld.
@wijanarko19797 жыл бұрын
How much minimum diamter (with bevel) koike can cut ? Can the 3D bevel head cut 31 mm diameter (with bevel) ?
@KoikeAronsonRansome7 жыл бұрын
The minimum inner diameter is 16mm and outer diameter is 25mm with a 40 degree bevel.