Xtreme Efficiency: Plastic refinishing for a maximum profit

Рет қаралды 1,879

2 жыл бұрын

The drive to simplify and enhance our product systems is a challenge that we continue to enjoy at Standox. Now thanks to the use of innovative technology users of our well known Standox Xtreme system can benefit from rapid processing, easy application and fast drying when refinishing plastic parts. When used with Standox U7600 VOC Xtreme Filler/Standox U7650 VOC Xtreme Wet on Wet Filler the new U7660 Standox VOC Xtreme Plastic Additive provides the adhesion and flexibility required when painting plastic parts without compromising on the quality and performance users have become so familiar with and appreciative of. Additionally, this also offers users the possibility of a pure white wet on wet filler for plastic refinishing, very useful when considering the amount of white cars on the road today.

Пікірлер: 9

@radudanielman 2 жыл бұрын

👍👍👍

@simonwood8685 10 ай бұрын

Hi we have the non stop wet on wet and use it with the plastic additive... But we only seem to have the wet on wet primer in light grey or black... What is the part no. For the pure white wet on wet.. Thanks

@StandoxOnline 10 ай бұрын

Hi, thanks for asking... Article reference: 02078134 Material code: 4024669781342 Hope it helps...

@apap5786 Жыл бұрын

Thank you for always providing great information. Is there a difference in gloss after drying the clear compared to U7580? I'm currently using U7580, but I'm worried that it will die back slightly after drying even if I adjust the drying time and application method.

@StandoxOnline Жыл бұрын

Hi, thanks for the question. If you are flashing the U7580 correctly then there should be no difference in the final result. Please remember though that if you are not using the completee Xtreme system you will need to activate the basecoat before applying VOC Xtreme Clear.

@apap5786 Жыл бұрын

@@StandoxOnline thank you for your reply. In the case of wet on wet, even if the flash time is long, there is a very slight loss of luster (slight loss of texture). STANDOBLUE base coats have added hardeners. There is no problem if it is not wet on wet. I'm thinking about using the U7650 and lightly sanding the whole at around P1000 after a short flash to get a better finish. I'm Japanese, so maybe I'm overly concerned about the details, but I'd be happy if there was a solution.

@StandoxOnline Жыл бұрын

Hi, thanks for using our products. U7650 can be overcoated after 5 minutes depending on the climate conditions, but can also be left for up to 8 hours without sanding. Within that time you can slightly sand the wet-on-wet to remove some dust inclosures or paint defects. The U7650 has a very nice lay down with smooth texture. Usually there is no need to sand just to remove structure. This product is designed for highest productivity. So sanding by defaukt each time would counteract this productivity advantage. If you prefer a fast and efficient sanding process of filler or surfacer, you should check if U7600 VOC Xtreme Filler might fit better to your workflow.

@apap5786 Жыл бұрын

@@StandoxOnline I will be getting the product soon and testing it out. Thank you for a polite answer. I look forward to more technical videos.

@StandoxOnline Жыл бұрын

Glad if we can help...

11:36

Special finishes: Standox Matt Clear Systems

Standox

Рет қаралды 3,8 М.