Wear headphones for best experience. 2x 6Ω 60W Panasonic speakers 12” 4Ω 350W passive PA Subwoofer (127dB SPL rated) 32V 5A power supply
Пікірлер: 30
@paakobinabartelscudjoe80108 күн бұрын
Hi there. When you turn the amp on, does it play any notification sound?
@abinash200722 ай бұрын
I use this board with 36v 20a power supply
@playgo4352Ай бұрын
What did you think of the subwoofer's bass, is it strong bass?
@abinash20072Ай бұрын
Heavy bass@@playgo4352
@ssaseev8640Ай бұрын
@@playgo4352 Bass is great! Check out my latest Short for this amplifier here: kzfaq.infoT3ixOyC8z1E
@abinash200722 ай бұрын
You use a 160watt power supply........but board's rms power is 790 watt....sound is definitely compromised please use proper supply and review on it....
@ssaseev86402 ай бұрын
I don't know where you picked up that the power output is 790W RMS, it's not true. It's a TPA3251 and with 10%THD you can get 350W out of that chip and that's on MONO and 2 ohms. I have a 350W subwoofer, why do you think I can feel the coil overheating at max subwoofer volume? I don't need a new power supply, 32V 5A is perfectly sufficient for my stuff. I didn't make this video to show what MAXIMUM power this amp has, but how it sounds with the power supply you can buy for it directly from the manufacturer's site.
@sitiocampeiro6 ай бұрын
Q sound good..top
@moroccanorthern21Ай бұрын
How’s the sound quality and bass ?
@ssaseev8640Ай бұрын
A lot depends on the speakers you use here. I use a 12-inch PA Subwoofer and the power, dynamics are great. I also tried to sound a outdoor party with this amp and it handled it beautifully. The volume is excellent, the bass is excellent as well, I simply have nothing to complain about for the price.
@coolmonkey52696 ай бұрын
does sub freq. low pass works nicely. and bass trebel tone control
@ssaseev86406 ай бұрын
Hello, yes it works well, but at maximum volume you'll have to turn down the volume on the subwoofer because the amplifier will start to distort. I haven't explored yet whether it's a problem due to a weak power supply. But yeah, worth the price.
@Handlethatineedtouse3 ай бұрын
@@ssaseev8640I had the s220h and when the bass hit I had sub volume on max and the amp exploded so watch out
@abinash200722 ай бұрын
Is it have floor shaking bass ?
@ssaseev86402 ай бұрын
It depends on your speakers. If u will use box with good acoustics and with good driver (30-120Hz response) then yes. My subwoofer has acoustic foam in it, so the bass is really strong with good frequency
@thebestgamer80148 ай бұрын
how did you connect PA subwoofer into this amp? and does it sound good with it?
@ssaseev86408 ай бұрын
My PA subwoofer has a speakon input, I used "bare wire to speakon cable" you can find it on amazon. And to the second question: yes, it sounds good. But it is good to mention that I only have a 350W and 4 ohm subwoofer. With bigger RMS power of the speaker and bigger impedance, I think it will not sound good (especially in the outdoors), because bigger impedance = less power from the amplifier.
@matamistavineslateyevernig82382 ай бұрын
this amplifier will sound good in high current (ampere) atleast 24v 20a
@ssaseev86402 ай бұрын
I think that 20A is too strong of a current for this amplifier; the website states a maximum of 10A. However, if you have tested it for a long time and nothing happened, then yes, the performance must be great.
@matamistavineslateyevernig82382 ай бұрын
@@ssaseev8640 yeah i think it really does need strong current cuz the amplifier output wattages is high
@stefanflorin2884 ай бұрын
I have this amp with a 4ohm sub, but o dont get that mich bass on the sub channel, i get more bass on the LR channels......sucks
@ssaseev86404 ай бұрын
Try to replace two big capacitors next to heatsink. Try using good brand capacitors.
@eletronicsjugaaad7413 ай бұрын
How much price sir
@ssaseev86403 ай бұрын
You can find it on Aliexpress for about $50
@wexleroww4 ай бұрын
Hello mate! I want to build a DIY speaker system with this amplifier onboard. My midrange speakers have an RMS of 60 watts, while the subwoofer has an RMS of 300 watts. Essentially, at 50% volume, the midrange speakers will be nearing their limit, while the potential of the subwoofer won't be fully utilized. Personally, I want the system to focus on the bass, with the subwoofer playing to its full potential. So, here's the question: Is it possible to independently adjust the volume of the subwoofer channel, allowing me to boost the sub without overloading the midrange speakers?"
@ssaseev86404 ай бұрын
Hello, sorry for late reply. Subwoofer has its own potentiometers to adjust the bass strength and also the frequency, but the volume can be only adjusted at the same time, so you cant adjust the volume separately on the subwoofer and separately on the L and R speakers. But i think the 60watt speakers will do just fine at higher volume, I myself have 30watt speskers and i tried this amp at max volume and they survived just fine, but of course the bass was set to minimum on L and R output, also this amp has a protect mode, so when the speakers get too overheated it shuts off. So if youre planning on using this amp and you want to plug in weaker speakers i’d recommend you turn down the bass on the L and R outputs and speakers will definitely survive.
@wexleroww4 ай бұрын
@@ssaseev8640 Alright bro, thank you very much for your response