No video
Y-Axis Bearing Maintenance
Рет қаралды 1,137
Күн бұрын#3dprinting #prusa #maintenance
I recently purchased a Fysetc Prusa MK3S clone and forgot to grease the bearings while I was assembling it. In this video, I pack the Y-Axis LM8 bearings with grease with as little disassembly as possible.
-------
90 deg adapter: www.printables...
Super Lube No. 21030: a.co/d/3n8MMFs
--------
@flyroger12 Жыл бұрын
I just use 10W30 motor oil. No grease.
@CSWilsonPrints Жыл бұрын
I debated about using an oil instead of grease, so I did some research. What I found is that it's largely preference, since they both have their pros and cons. Upon the recommendation of a couple of "information repositories" I trust, I decided to use the Super Lube No. 21030. We'll see how it holds up.
@flyroger12 Жыл бұрын
@@CSWilsonPrints I have used oil for over 20 years and still have the same bearings and rods. It is also very easy to keep clean. Only need a couple drops after a couple hours of use.
Made with Layers (Thomas Sanladerer)
Рет қаралды 152 М.
Chris Riley
Рет қаралды 29 М.