Thanks for this video. I believe I have an oil leak throught the gasket on this cover and this video really helps!!
@paulwildasr2008 Жыл бұрын
I bought an 07 xv250 and now I'm having problems with it starting. Someone told me it could be the stator, but before I do all that, I'm going to be putting a new battery in it anyway. I don't know how old the current battery is so I was already planning on getting a new one. If that doesn't work and it is the stator, this video did help. Thank you
@Virago_XV Жыл бұрын
Exactly what i needed to know. Thank you!
@96domatyo3 жыл бұрын
Thank you this really was helpful!
@EvilSapphireR10 ай бұрын
Why is there a ground wire? Is it to connect the alternator body to the chassis to ground it? I don't see a ground wire going into my rectifier, only 3 wire from the 3 phases.
@procaio915 ай бұрын
Man, thank you. I'm Brazilian, and here, it's pretty difficult to find someone to make this kind of vídeo. I need to replace this litlle sensor, I'm not sure How do I make this replacement. Can u help me?
@bobbertomster2 жыл бұрын
Did the bolds came out easy? With a normal screwdriver or did you use a powertool?
@mickzulyevic98822 жыл бұрын
I always use a rubber mallet and hit the screwdriver while turning so I don't strip the bolt.
@rynraff2 жыл бұрын
Do you recall a clip holding the starter gear inside the block? My starter is bad and I’m wandering if I can just pull it and put a new one on without opening the block
@mickzulyevic98822 жыл бұрын
It's been a long time since I did that however I don't remember seeing that, I would assume you would be able to remove the starter without having to pull the side case off :)
@eliotech1928 Жыл бұрын
I have problems with removing the screws holding the stator and sensor.... Any suggestion??... Ob better, is it possible or I have to change all the carter?😢
@alfaman41136 ай бұрын
Why do you have to drain oil
@hilmarsauerwein5381 Жыл бұрын
How did you get the new gasket back on without taking off the wires?
@mickzulyevic9882 Жыл бұрын
I believe you can unbolt the harness and run It through, it been a bit since I've owned this bike so I honestly do not remember, best of luck !