Hemos llegado a 1000 amigos de los gorilas en el canal y lo celebro con una entrevista especial!
Gracias a todos!
Voy a dejar aquí una pequeña chuleta por si a alguien le pasa también lo del indicador de marchas:
Deactivating the SL and HSW features
If you wish to deactivate or re-program the Shift Light or High Speed Warning features, perform the following steps:
-
Park the bike and turn ignition On (if it is already on, cycle the ignition key).
-
Start the engine in neutral, and warm the engine if necessary.
(Do not move the bike, otherwise you will need to restart the sequence.)
-
Gradually and very slowly increase the RPM, and keep it in the range 3-4 times of your idle speed (usually 3000-4000 RPM).
As a guide, the display will show a “¯” (top horizontal bar) sign when you keep the RPM in this range.
-
Hold the RPM for about 5 seconds, until “C” (Clear) is flashing on the display.
-
Now, if you wish to deactivate both features, stop the engine or turn the ignition Off.
Otherwise, continue to step 2
Step2
Shift Light
If you wish, you can program the device to indicate when the desired RPM is reached.
The unit will rapidly flash a “U” (Up) once you exceed the pre-set RPM. The feature is intelligent, as it does not operate in top gear. To activate the feature:
-
First, perform the deactivation steps as per chapter 8.
-
When “C” (Clear) is flashing, raise the RPM very slowly.
-
The display will begin flashing a “U” sign, indicating that the Shift Light learning is in progress. The unit learns the highest RPM.
-
Raise the RPM gradually and very slowly to the desired RPM, and hold it for a second. Release the throttle.
-
When done, you can save the setting and exit from the learning mode in three ways: start riding, stop the engine or turn ignition off.
Sígueme o ponte en contacto conmigo a través de:
Instagram y Telegram: @GorilaEnMoto