Yamaha R1/R6 immobaliser bypass explained/theory.

Рет қаралды 7,802

R.B Cycles

Жыл бұрын

Пікірлер: 11

@tradinglabvix 5 ай бұрын

Hi there, so far did it work ok!!!! I have the same problem

@lancemarshall4660 7 ай бұрын

If I just joined the 2x reds without putting the emulator chip in would I be good to go or does it still have to have the chip present?

@neatbone3112 Жыл бұрын

How is it installed on scooter?

@andywilson7718 11 ай бұрын

will the two red wires not need cut beyond the crossover wire to stop signals being sent ?

@tradinglabvix 5 ай бұрын

Hi did you fixed

@kznspraynozzlesandsystemsp8075 Жыл бұрын

Tried this on r1 2005 model doesnt seem to work 😢 Also gives Hi temp and no immobilzer flashing

@cyberkiller83 11 ай бұрын

The HI is an indicator that the circuit from the ECU and the mobiliser is OPEN (HI RESISTANCE). If you check the mobiliser you will find that the cables that goes to the blacks, makes a jump, so if you make a jump on the harness from back to black you will get the HI caption gone, now maybe the bike doesnt start but at leastr the HI is gone.

@tradinglabvix 5 ай бұрын

Hi Did you fixed it :)

@gtgboysma4563 8 ай бұрын

🦾

@doreilly7689 2 ай бұрын

Jou skelem bliksem lol

@googlelimp9834 3 ай бұрын

anyone followed this? i have a Tracer 700 just stolen then found so bought it of the salvage and now showing £1000 for a new kit or second hand £500 f%^k that so with key until I buy a new key and barrels anyone know how tostart with out the keys??