Yanmar 3GM30F Starter Repair Cleaning

Рет қаралды 7,564

Gunnar Kjemphol

Жыл бұрын

Brushes are flatened, starter are cleaned.
Brushes are reinstalled by use of tube.

Пікірлер: 16

@Breal191 Ай бұрын

Way out of my comfort zone. Especially with the edits, but thank you! I’ll know what to do if i had to.

@ken2633 Жыл бұрын

My engine is year 2002. I suppose I'll need to clean the Starter like you did, so i ordered a new Starter just to standby in case I ruin the servicing 😊 Thanks for the video❤

@mikeamirault8741 Жыл бұрын

Nice video with no annoying music. Thanks!

@alilasail 26 күн бұрын

great access. its not always like that on boats

@montanadan2524 10 ай бұрын

I would recommend dropping the RPMs to around 800 when starting as to allow the oil pressure to build.

@gatecrasher1970 7 ай бұрын

also if i put the circlip on the back of the shaft it jams the shaft from turning but yours went on real easily? mine got a small spring at back instead of a washer

@gatecrasher1970 7 ай бұрын

please tell me why you left the air filter in the way lol?

@beaconbus Жыл бұрын

Nice job! Did that fix your starting issues?

@gunnarkjemphol Жыл бұрын

Yes. It working each time now. I sanded the brushes flat, that cold help, since one was lopsided.

@lamisura757 7 ай бұрын

Hi Gunnar, you seem to be a very familiar with a Raymarine tiller pilots. Perhaps you could help me about my ST2000+ tiller pilot... My brand new tiller pilot does not hold the course in AUTO mode. When I set the desired course in STANDBY mode and press the AUTO button the push rod (little by little) goes completely out, or completely inside, and the boat start circling endlessly. However, if I remove the tiller pilot from the pin, and steer the boat manually (left - right), holding at the same time tiller pilot very near the pin it reacts normally, as it supposed to do in AUTO mode, the push rod goes IN and OUT normally accordingly to my (left - right) steering... but when I put it back on the pin it no longer holds the course again. Thank you very much.

@gunnarkjemphol 7 ай бұрын

have you calibrated the Tiller pilot? Se in the manual, and start calibration when you make 360 degree circles with the boat in 3 minutes.

@lamisura757 7 ай бұрын

@gunnarkjemphol Well, yes, I did calibration. It's a very simple procedure, as everything else ... that's why I am so confused. I plugged tiller pilot to power, it shows "C" with the current course, I set the desired course and press "Auto" button to start automatic steering, but it just won't keep the boat in settled course.

@lamisura757 7 ай бұрын

as for the calibration process... I start turning the boat in circles, speed lower than 2 knots, about 4-5 minutes per circle. As soon as I made 1 whole circle, it shows the deviation amount, I believe it was 5, then I trurn the boat in a steady course and aligned the tiller pilot course that was shown on LCD display, and finally pressed "Standby" button for 1 second to save calibration... I believe it was done correctly.

@ken2633 Жыл бұрын

How old was the engine or running hours before servicing the starter?

@gunnarkjemphol Жыл бұрын

I do not know running hours, and year. But based on serial number I guess the motor is from year 2000