Yaskawa V1000 Motor Parameter Setup

No video

Yaskawa V1000 Motor Parameter Setup

Рет қаралды 97,296

Control Assemblies

Күн бұрын

Step by step instructions for setting up the motor FLA and RPM in a Yaskawa V1000 drive.

Пікірлер: 19

@anapaulina3213 4 жыл бұрын

Hola podrías apoyarme con los parámetros de yaskawa V1000 para una aplicación de presión constante PID con transductor de presión de 4 a 20mA 0 a 16 bar . Te lo agradecería mucho. O como podría hacer que me arranque cuando detecte baja presión y al llegar a cierta frecuencia pare y vuelva a arrancar con bajo presión. Me urge porfavor responde.

@theultimatefashion4492 6 ай бұрын

Me puedes ayudar. Como puedo cambiar las velocidades la frecuencia en este variador. El funcionamiento es el siguiente. Es un despaletizador de sacos. Sube el elevador coge el saco y anda la cesta con los sacos a 20 Hz hasta llegar a una fotocelula que al detectar baja la velocidad a 7 Hz al estar unos segundos vuelve para detrás a 20 Hz y al volver a tocar la fotocélula de dónde está el elevador de sacos baja a 7hz hasta llegar a otra fotocélula que para la cesta. Mi pregunta es cual es el parámetro que tengo que tocar para cambiar 20hz por 30hz ?

@user-hx2wf6ot3j 7 ай бұрын

been trying to set S7 and S6 terminals for H01.07&6 to 07 and 09 for NC even tried 0d and 0b for NO for travel limits and it is taking the settings and flashing for upper limit and lower limit but it is just locked up, i have good continuity coming through limit switches wired for NC, i am thinking the interface terminal board may be the problem cause the settings were 0F as found like no one ever set the limits on the terminals. Any feed back is appreciated.

@herdemgermiyani6438 4 жыл бұрын

Thanks for the video. I have a question if you could help me with it please. Is it correct and safe to install digital control panel unit between the inverter and water pump motor to make things simpler and get some other benefits like timing... Etc that the inverter wouldn't offer. Thanks. Thanks

@jalesaucedo 3 жыл бұрын

Awesome...Thank you

@hibaaboudi43 Жыл бұрын

Hi, How to parameter the inverter v1000 for several motors Thanks

@jvjayaraman2483 2 жыл бұрын

Sir v1000 inverter when I changing frequency busy message coming, what's the problems

@mohammadabdulfattah1867 2 жыл бұрын

Sorry I have question one I open parameters , show A1_01 and continue flushing so I can't access to parameters by the way this new one ....please I need your help

@joselizard2794 6 ай бұрын

Push the reset button and it should let you access the A1 and it should start flashing. If that doesn't work. Enter the password on the A1-04. If you don't know the password it's in the A1-05 to get to that push the up and stop button at the same time and it should tell you what the password is because this parameter is hidden.

@markodenbrett4363 Күн бұрын

@@joselizard2794hey how do you adjust the Herz if you can help it would be greatly appreciated