Zero Turn No Power, Bogs/Dies Under Load How To Diagnose Easy

No video

Zero Turn No Power, Bogs/Dies Under Load How To Diagnose Easy

Рет қаралды 109,012

Күн бұрын

Thank you for watching!! If we helped you out and you want to show your support - LIKE, SUBSCRIBE or give us a shout out below. If you saw something you didn't like leave your comment below as well, these things help us get better!
To see our recommended tools and products visit our Amazon shop at www.amazon.com...
We check out and diagnose running issues on a Toro Z Master Commercial 2000 series zero turn mower.
The customer said that the unit did not run right when blades were engaged. We go through the full diagnosis process to find out what is wrong.
Follow up to come for repair after head gaskets come in.
Toro Model 74143 serial number 312******
Kawasaki Engine Model FX691V-AS19 FX691V-AS19-R
Valve cover gaskets part number 11061-1285 can be purchased at amzn.to/47DCjnP
Carburetor intake gasket (will need 2) part number 11061-7092 can be purchased at amzn.to/47OX8g8
Carburetor manifold gasket part number 11061-7093 can be purchased at amzn.to/46NMoNB
Oil seal part number 92049-7017 can be purchased at amzn.to/41b1trm
Oil seal part number 92049-7028 can be purchased at amzn.to/3Gws34G
Head gasket (will need 2) part number 11004-0762 can be purchased at amzn.to/4adEDDC
Permatex ultra grey sealant can be purchased at amzn.to/3thDlqu
Find the follow up video at • Zero Turn No Power, Bo... where we do the final repair
Like and subscribe to see more helpful videos like this one! Save some money by doing it yourself!
#toro #kawasaki #smallenginerepair #individualizedrepair #smallbusiness #diymaintenance
About Us:
My name is Martin. I have been repairing tools and small engines for almost 20 years. We operate a small engine repair shop in Illinois. We service / repair Briggs & Stratton, Kohler, Kawasaki, John Deere, Cub Cadet, Toro Tecumseh, Loncin, Honda, Craftsman, Husqvarna, MTD, Troy Bilt, Simplicity, John Deere, Exmark, LCT, Generac and many more brands. We work on riding mowers, walk behind mowers, snow blowers, zero turns, generators, pressure washers and much more. We normally repair about 3,000 pieces of equipment every year and look at many more that are beyond an affordable repair. Hopefully our videos will save you some money and give you the information you need to work on your own equipment or figure out the issue at hand.
Disclaimer: Links included in the description are affiliate links. As an Amazon associate we earn from qualifying purchases. There will be no additional charge to you for purchasing here. We appreciate your support, which allows us to continue to provide original content!
Please be careful when repairing any piece of equipment and follow all possible safety measures. This video is for entertainment purposes only.

Пікірлер: 63

@chrisowen9378 Жыл бұрын

Super professional !!! Videos show diagnostics and troubleshooting on a commercial level. Even though I I rarely use them anymore because of seat of the pants experience. Your viewers might want to see a leak down test or a compression test. I hope your channel really takes off.

@IndRepair Жыл бұрын

I appreciate that! Thanks for your advice! Many times we forget some viewers may actually have the correct diagnostic tools available!! Will be doing the followup may show compression test before breakdown! Thanks for watching!

@pauldiesel4582 11 ай бұрын

Thank you! I just figured out I lost 1 cylinder from a bad ignition coil. I was surprised at how smooth the engine ran on 1 cylinder, although the top speed seemed lower and was much quieter!

@IndRepair 11 ай бұрын

It is quite crazy sometimes how little difference it seems! Thanks for watching!

@philliphall5198 Жыл бұрын

Leak down test is a must anymore, can’t take a chance Time is money and parts are expensive

@IndRepair Жыл бұрын

Valuable tool in many situations

@ukmerkz5031 Жыл бұрын

I got this mower specifically to be able to drive it through a 36 inch door kzfaq.infoUgkx1VWTrayKBdCKAjzAcZ_Eg4dhHTae3LkN also recommend or gate It is a little tight with the grass deflector installed but has more clearance with the deflector replaced by the recycler/mulcher. This model appears to be popular and a little harder to find for that reason. I can't judge the dependability as I have only mowed the yard twice but everything else on the mower is very nice and working fine so far. I added options for the run hour timer, arm backrests, recycler/mulcher, towing bracket, deck lift assist and cover.

@IndRepair Жыл бұрын

You and me either!!!

@doubleed86s55 Жыл бұрын

You just diagnosed my problem.. thank you sir!

@IndRepair Жыл бұрын

Glad to help! Thanks for watching!

@Dan_Akins 4 ай бұрын

Well done sir!

@IndRepair 4 ай бұрын

Thanks for watching!

@George1mac Жыл бұрын

Thanks......gives me something to go on....2010 Toro Z 500 that started losing power and dying when turning up a hill to the right....I figure it must be something to do with fuel pump or filters....the mower has two gas tanks, so it is not due to gravity issues...runs fine on flat ground but weird that it only does it turning right up hill.

@IndRepair Жыл бұрын

It sounds like a crack in the pickup tubes to me just off the top of my head

@bobkernahan6340 Жыл бұрын

I had same problem on my zero turn It was my hydro gear slipping going uphill when hot, outside temp was 96 and problem got better if I let it cool for a couple minutes, I haven't fixed it yet as I'm trying to nurse it till grass slowes down Sorry I missed that you said it was dying also, oh well mabey someone is having same problem lol

@George1mac Жыл бұрын

@@IndRepair Thanks for suggestion, I gave the fuel lines a good lookover....grommet at tank looks good and has a metal connection to fuel line....I found slightly loose carburetor retainer bolts and tightened them and cleaned the area....I let it run and checked for leaks. I really thought that might have something to do with it, but after taking it to the pond bank and mowing, it has the same symptom...starts to die when turning uphill on pond bank to the right. I have mowed that area for years without this happening. Turning to the left uphill will not cause the problem...starts ok and runs ok on flat or slightly inclined areas just fine....scratching my head....I guess I will drain the tank and check inside to make sure things are not clogged there, but makes no sense to me for it to be happening in only one direction

@IndRepair 6 ай бұрын

Did you find the restriction or break?

@George1mac 6 ай бұрын

@@IndRepair I never found any type of break or other restriction that I could identify....has been cold here in East Tennessee the last few months so I have not done any mowing...just started the mower after a few of the worst cold snaps to keep it up. I guess we will see what happens as season comes on

@JerryScally-cs9dr Жыл бұрын

My cub cadet 0 turn with a carbureted Koehler engine leans out on side grades. I checked the carb cleaned it was clean inside anyway and the float looked good it has plenty of power except on the grade , when fuel tank is on the low side. If you can help thanks

@IndRepair Жыл бұрын

Could be a crack in the pickup tube coming out of the tank

@thomasroche164 Жыл бұрын

Nice. Great explanation.

@IndRepair Жыл бұрын

Appreciate you watching and the kind words!

@christiantutela5936 11 ай бұрын

My kabota sz1936 bogs out and when I Pull my left side hand lever in reverse motion!?! What can this be!!!!! Please help

@IndRepair 11 ай бұрын

I have see a bad brak3 on some of the hydros cause this issue. Make sure the brake is fully disengaged when that left lever is reversed, my bet is that the brake locks the hydro in when you have it pulled back so it is bogging the engine when the hydro tries to work against the brake

@adamruter8412 Жыл бұрын

I have a cub cadet i1050. It doesnt have enough power to mow when you start cutting grass. I did the spark plug wire test and when i pulled the one wire off it quit immediately. However when i pulled the other side off, after i connected the other side back up of course, it kept running exactly the same as before i pulled the wire off. What does this mean?

@IndRepair Жыл бұрын

The side you had connected when the mower died is not working. You have a bad coil, blown head gasket, bent push rod, stuck valve or something else going on with that side

@dgmenace73 Жыл бұрын

Nice video! I have a 2001 John Deere Ztrack M665 with 25hp v-twin. The problem with mine is as soon as I engage the drive it shuts off completely. Almost like a kill or safety switch. New fuel and firing both coils....do you have any suggestions or seen anything with the m665? Thanks in advance!

@IndRepair Жыл бұрын

Soon as you pull in one of the arms it dies? If so usually the seat switch but could also be one of the arm switches, brake switch or PTO switch. Will need to test them all with a meter to find out for sure. Thanks for watching!

@dgmenace73 Жыл бұрын

@Individualized Repair It "was" doing just that. As soon as I moved an arm it shut off now its runs for maybe 5 sec then its goes completely dead. I did notice the ignition switch now has a "sweet spot" to crank it over. If I turn all the way clockwise it does nothing, I have to back off a little and it hits that slots fires up then immediately dies. Any additional advice would greatly be appreciated. It has a very unusual carb on it...20yrs of working on small engines for myself & others and never seen one like it. The reason I mentioned carb is because I was thinking maybe it wasn't getting enough fuel? Idk at this point

@IndRepair Жыл бұрын

If ignition is throwing problems start there for sure

@dgmenace73 Жыл бұрын

@Individualized Repair thanks for your fast replies. Where can I find this ignition switch or the model #? There's not much online for the JD Ztrak M665. Thanks again.

@IndRepair Жыл бұрын

You can go to partscatalog.deere.com/jdrc/ for all the parts you need. Part number is TCA51267

@dakotak8437 Жыл бұрын

I have a cub cadet 60inch 24 or 27hp can anytime I get into a little bit tall grass it want to bog bad I did air filters sharp blades ne oil good gas everything runs cleaned carbs still bogs. Any ideas and been taken to dealer and no Idea.

@IndRepair Жыл бұрын

Normally carb issue, fuel issue, air leak, blown head gasket, etc, etc... really hard to tell without going down the line of troubleshooting. Has a compression test been done?

@dakotak8437 Жыл бұрын

@@IndRepair ya everything was check and done I found out the valves can be done bc they hydraulic iv tried turning up the rpm and still will just bog

@IndRepair Жыл бұрын

@@dakotak8437 Something had to be missed for sure...I would go right back down the line. Leak down test was performed also?

@dakotak8437 Жыл бұрын

@@IndRepair the test I don't think so.

@dakotak8437 Жыл бұрын

I'll prob have to take it to someone else bc I'm stamped

@RemyAlphaElite 11 ай бұрын

I had a governor replaced on mine and it keeps shutting off. It'll run and cut but fluctuates with power/gas..whatever it is. For like 5-10 seconds it'll Rev high but then drop down and eventually after 1-3 hours it'll die

@IndRepair 11 ай бұрын

Strange issue..

@Calidog_Tex 5 ай бұрын

Check your fuel filter, it could be dirt and could be a cheap fix before taking other steps . 1.99 fo me as it's running like it should.

@IndRepair 5 ай бұрын

Absolutely! Thanks for watching!

@js4455dl Жыл бұрын

They told me today i had a bad module on mine it was making a noise and was running bad said it wasn't running on all cylinders

@IndRepair Жыл бұрын

A bad ignition module is very common! Thanks for watching!

@redboyize Жыл бұрын

@@IndRepair I have a Koehler command pro ecv749 on a scag cheetah it boggs down loses power when cutting grass it engages well with no problem but when I move from the driveway to the grass it just boggs down in about a few inches of grass ….. any ideas?

@IndRepair Жыл бұрын

@@redboyize Have you verified both cylinders run independently?

@redboyize Жыл бұрын

@@IndRepair yes I noticed it runs extremely high rpm’s at idle also seems the throttle lever is not working properly can’t control the idle function it’s always rived up

@Underthegreen Жыл бұрын

So did you put head gaskets on that mower? How did this end?

@IndRepair Жыл бұрын

See the finish at kzfaq.info/get/bejne/mtpmdaqQlbiYnpc.html

@jacobtrent3423 Жыл бұрын

Thanks!!

@IndRepair Жыл бұрын

Glad to help!

@kimdj2003 Жыл бұрын

Compression test??? What was the actual outcome?

@IndRepair Жыл бұрын

You can find the final repair on this at kzfaq.info/get/bejne/mtpmdaqQlbiYnpc.html

@kfreshdrip3496 Жыл бұрын

👍🏾

@IndRepair Жыл бұрын

Thanks for watching!!

@UncleScotty 6 ай бұрын

Compression test, perhaps?

@IndRepair 6 ай бұрын

Definitely! The people who have a compression tester available are likely not watching. This is for those that don't. Thanks for watching!

@philliphall5198 Жыл бұрын

I had one come in with using oil and very low power Plugs were oil wet , pulled air cover and no filter at all F Re ringed it and later found out a mad hird hand removed them when it went to using a lot of oil quite

@IndRepair Жыл бұрын

Things are sabotaged so workers get out of doing their jobs all the time