Good stuff. My DRL bulb burned out and was wondering what I needed to remove to get behind the bumper to access the bulb.

Promo>SM 😪

Could you please tell me the size of the oil cap in the video of the Dodge Ram 1500 with the dimensions and part number? I have a 2007 Dodge Ram 1500 SLT Quad Cab V8 Magnum and recently discovered it had no oil filter cap! I had to use my gas cap to cover it. I have been searching for one to fit, but was unable to find it. When I called the parts department of the Dodge Service Center, they said it had been discontinued. I tried buying a few on Amazon thinking they'd fit, but they were all too small. Thank you SO MUCH for your help.

9005 is for DRL and headlight? Is the same with HB3?

Cap isn't Stu k mine blows of and sounds like a cannon under the hood. Does it after about three miles something is letting back pressure into the crank case. PVC valve or bad sensor

Finally found the video I needed. Man, that cap is crazy tight. I thought I was just weak,lol. Thanks.

Thank you for posting this how to video It saved us so much time and effort to change out the bulb on my MDX.

Thank you so much for taking your time and sharing this video.

Broo exelente información ℹ️ 👍

Thank you very much. Easy to accomplish.

Sig? 365? Hard to tell from here but great guns.

Thanks, wife brought one of these home a couple months ago and one of these just went out.

To make the electrical installation better add daytime running lamp relay from EBay or Amazon

What's the point of this video?!? Why not to show what to hook the RAV for?

Thanks for the video, very helphful, I just bought the LED white bulbs but I like how the yellow ones look, what brand are those?

Why do I need these lights? I just had replaced and it’s out again. Can I turn off warning code without replacing? I’d rather

Thanks a lot for the video and it really helped me! I had to replaced passenger side one a couple of years ago and this time for the driver side one as well. The lesson I learnt from the painful experience is how to pull it out within such tight space, which was echoed by many commenters below. The trick is to roll the front wheel to the most of other side so you have enough space to rotate the bulb out. i.e., If you replace left side DRL bulb, turn your front wheel to the right most. As I don't have strong arm 😊 , the extra space really helped me put enough strength to rotate the bulb out (counter-clock wise).

Dont use your thumb to rotate ccw or ("left"), use middle and ring finger.

The real question with this installation to LED bulbs is this: Will it trigger a warning code since LED bulbs require less voltage to illuminate? Some vehicles require a certain type of resistor to work.

Nope it don't work. You have to use channel locks. Getting it back on is just as hard smh

Thanks. Used your video to replace my DRL. The stealership wanted $45 for labor.

Thanks. That helps.

Do u know how to adjust the headlights? My left headlight was completely replaced but it was not aimed correctly so the beam is off.

Thanks for posting, when I tried this on my car the bolts underneath wont budge because they are so rusty and they feel like they're gonna RIP the whole fender off, infact one of the bolts broke right off, any suggestions?

Do you know the size of the bulbs both RnL?

Mine was extremely tight in the holder plus the fact that it is an extremely tight space. Finally had to spray some WD40 around it to get it to break free but was finally able to get it out and change the bulb out. Can’t wait to change the other side eventually 😭

The view inside and outside of the lights is very helpful in identifying which is the one to be replaced. Great thanks!!!

At Johnson wu if I replace the drl with a white halogen bulb will the error code still show up

When I turn on all my headlights at night the fog light bottom to the right is not on..but when I turn off all my headlight..both daytime fog lights work..so does that mean I have to change my fog light instead of the daytime running light?

Thank you

What is that hose connected

Didn't help me...there's a bolted hard plastic air duct in the way on my 2011 MDX. Didn't see it on your video. I had to remove the bumper to get at the bulb...typical of Honda cars...

Thanks, I have the same car and your video was helpful.

did you get any error code?

This just helped me BIG TIME

Thank you for this. My cap on my Durango was so tight it wouldn't budge. I lightly tapped around it with a hammer and it popped off with one twist.