Thank you for the great video. Am I correct in assuming that I cannot set the on timer and the off timer to work in succession. For example, I want the heater to come on in 1 hour for then turn off an hour later when I am away from my caravan. I might want to do this if I know it will be freezing tonight and I want to heat up the interior for a little while in the middle of the night. It looks like I can only activate the on time timer when it is not running and the off time timer when it is running but I need to activate each of these manually.
@2005micКүн бұрын
@@backdoc94 that is correct
@davidkelly24052 күн бұрын
How do you change language on controller; as mine is in Chinese
@CmteGrana3 күн бұрын
Please, how to pair the digital remote to the controller?
@2005mic3 күн бұрын
@CmteGrana see my other video. It explaines it
@Timetraveller101022 күн бұрын
Anyone know if there is a paper version on all these functions but great video anyway
@2005mic22 күн бұрын
There is nut hard to understand
@adamrobinson914829 күн бұрын
For 2 years i have been cooking in my van, always set temp but had it on manual mode, temp would go up to 30c + but now in automatic mode i set temp to say 15c its comfortable even though goes a little higher, great video thank you
@KurtDzinichАй бұрын
my controller lcd not bright hard to see indaylight?
@poderlover1528Ай бұрын
Wire kaunsa use kia for soldering? How much mm
@ross4702 ай бұрын
Brillent video just what I was looking as most videos are the other controller thanks! :-)
@raymatthews99782 ай бұрын
I have this same manual control. The system seems to be running ok, however the display never shuts off. It is drawing a small amount of power from the battery constantly. Does anyone know how to shut it off without disconnecting the battery? Sorry, I don't mean when the heater is running ... I mean when the heater is off and has not been used for some time. Suddenly the display is lit up even though the heater has not been used in a couple of months. Or was the screen always on and I couldn't see it in daylight?
@2005mic2 ай бұрын
No you can't sorry. The draw is minimal when dimmed
@Ian-ev5tg2 ай бұрын
Is it possible to program more than one remote?
@2005mic2 ай бұрын
Not sure sorry, never tried. If you have 2 remotes try it
@Twins6602 ай бұрын
How do you turn the screen off please
@2005mic2 ай бұрын
You can't. It only dims when not in use
@duncanmunday47353 ай бұрын
On this type of controller do you know how to put it into Hz mode as i need to connect it to a separate water heater controller
@2005mic3 ай бұрын
See my other video
@tarsneyisleestrelas46593 ай бұрын
Hi the heater i have is the upright all in one,its up and running but i, struggling to set the thermostat so it switches off at say 20c, help cheers.
@2005mic3 ай бұрын
Can only switch off after a set time, not available for temp switch off
@tarsneyisleestrelas46593 ай бұрын
@@2005mic ok so I need to set the clock and use the timer to turn it on and off at set times. Thank you have to set the clock first. Cheers for your help 👍.
@2005mic3 ай бұрын
You can only set 1 timer. Either on timer OR off timer. Not both
@danielpatryk21553 ай бұрын
Witam bardzo dziękuję za instrukcję co i jak ustawić bo nie wiedziałem nawet ja sparować pilot ze sterownikiem w nowym kontrolerze. Pozdrawiam!!!
@dodtaylor49753 ай бұрын
I have an e: 01 code coming up every now and again what’s the problem?
Hello, my screen is flashing E-09 and F1 apparently it’s a glow plug issue. Anyone know how to fix this? 🙏
@philophil19613 ай бұрын
Do you know, is possible to use heater only as fan? In summer, for air circulation and cooling. Thank you.
@2005mic3 ай бұрын
No it's not. Only as heater
@beauprephilip4 ай бұрын
why does a red circle with a red minus appear on the bottom right deisel starts then5sec trips?
@kingsleychant50904 ай бұрын
Hi Mic, great video and my has just started showing E-8 while trying to start up. Do you know what this may be? All I've been able to find is E-08 in Google search. Some say fuel issue? Can you enlighten me before I lose my sh#t. Cheer
@kingsleychant50904 ай бұрын
When it errors out with E-8 it doesn't show the red triangle in the top right corner like in the secret menu.
Same control panel as I've just received, did you manage to pair the remote please as I'm having no joy what so ever 🤔
@captainsensible35704 ай бұрын
Found it in your other video 😂 thanks mate as all up and running now 👌
@2005mic4 ай бұрын
@captainsensible3570 no worries im pleased the video helped
@sibfishingadventuresuk15584 ай бұрын
@@captainsensible3570 what video 😅 same problem
@johnwilson16204 ай бұрын
Can you fine tune the fuel/ fan ratio on this controller?
@2005mic4 ай бұрын
No you cant
@Ryderamazing4 ай бұрын
Please help. I have the exact same model as you and all of a sudden it turns off after blowing white smoke and saying error 8. When the inside case is heating it used to go up to 100degrees but now it doesn’t go any higher than 46 degrees. I don’t know what I’m doing wrong
@2005mic4 ай бұрын
Error 8 is lack of fuel. You need to check all lines, ensure fuel is primed to heater, glow plug is working correctly
@Ryderamazing4 ай бұрын
@@2005mic it still had a little bit of fuel in the tank left but I could see plenty of fuel still in the line as it was priming. Do you have any idea why the internal temperature only gets up to around 40 degrees now
@2005mic4 ай бұрын
@@Ryderamazing fuel may be contaminated with .moisture. must have plenty of fuel in tank
@CjTriker4 ай бұрын
hi , how long did you have to prime before the fuel reached the pump ?….also I have the blue controller and it appears to do exactly the same functions as your black one and the little blue icon by the air intake is exactly the same as yours but there are other blue controllers that function differently with a slightly different icon .
@2005mic4 ай бұрын
They self don't prime that well. You need to get the fuel to the pump, then prime from pump to heater
@sebastjantomazic88255 ай бұрын
THANK YOU🙏
@ezmur5 ай бұрын
Hello! is it possiple to use that "mountain" set for lower fuel consuption in sea level? its 1,6Hz for mountain and sea level 2Hz. beacause to me that regular "H1" mode is too efective.
@2005mic5 ай бұрын
The mountain setting is for high altitude where there is less oxygen. Hence to keep fuel air mixture correct. Useing it at lower altitudes will result in a lean burn resulting in shorter heater life
@metiel65345 ай бұрын
Danke ,,👍👍👍
@poolyboy815 ай бұрын
Excellent informative video. I was on the verge of goin to check into the nutty ward before i found your vudeo an realised I'd bought a heater with the new but looks the same controller. Much Love 😂
@user-xm2pc8nw3f5 ай бұрын
😈👍...Hi..I bought it for my garage, it works great,.thank you.!!
@user-jj3uz7tl8n5 ай бұрын
Are these controls interchange with the new one that has 3 buttons ?
@2005mic5 ай бұрын
Haven't seen the 3button one so not sure
@lucacavallini5616 ай бұрын
how i can reset the remote control pair for use in another identical display?
@2005mic6 ай бұрын
Just pair it on the new one
@stevejohnson54616 ай бұрын
Very clear and informative. Many Thanks
@jeffery68106 ай бұрын
swich the motherboard to the old style
@heintjeunger35806 ай бұрын
hello, is that an 2kw heater or an 5 kw - the temperatur of the heater from me just goes to 120°C yours to 178 °C - i have a 2 kw is that so low normal? ng
@2005mic6 ай бұрын
It's the 2Kw
@heintjeunger35806 ай бұрын
Ank you. It must be a failer by mine one. How much is your temp. Of output of air
@dantheman73706 ай бұрын
Clear as mud
@claritywithteekay6 ай бұрын
Legend! Thank you so much for this man! So so helpful!
@rudbeckia8856 ай бұрын
No light on control unit ?
@laska9076 ай бұрын
Anyone know how to change it to Fahrenheit?
@2005mic6 ай бұрын
Can’t be done on this controller
@tonylavender94236 ай бұрын
Great video! Makes it sooo much easier to understand. I have a question re: new style controller. Mine has an extra button between settings & ok buttons that looks like a fuel icon - any idea what it is for?
@2005mic6 ай бұрын
No. Haven't seen that one yet
@juliebest87606 ай бұрын
Any thoughts on why my power on off switch won’t work. I have to keep insert /remove the battery to start /stop👎 I used to on off with the remote but since changing the battery in the remote the remote doesn’t seem to talk to the main controller
@juliebest87606 ай бұрын
Don’t mean the battery I mean I have to insert or remove the fuse to start stop
@2005mic6 ай бұрын
See my other video. It explains how yo pair the remote
@mrmatt2525able6 ай бұрын
Thanks for the video. Good info!
@RealfishingNL6 ай бұрын
Awesome video. On this stuff i prefer an older grown up person who uses a pointing stick to make sure u cant get it wrong. No clickbait easy explanation keep up the good work please ❤
@RealfishingNL6 ай бұрын
Woooow amazing video. No clickbait no ads spamming. A great intro with the times explained. I just knew this was not kid that made this video. Very very very nice. Straight to the point. Great explanation. ❤👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍. Realy these days u dont find a lot of videos like this. Great job 👍
@user-pz4eh1di5t6 ай бұрын
E-2 error. my first battery wasn't strong enough for the glow plug. i switched to a big car battery and no error. hope this helps.
@user-pz4eh1di5t6 ай бұрын
E-2 error - i tried using a small deep cycle battery that couldn't energize the glow plug properly. switched to a big car battery and no error. hope it helps.
@TEM00ccc6 ай бұрын
The new remote control with OLED display has 2 x AAA 1.5V Micro LR03 cells. WTF A27 or A23 that annoys everyone. OLED display remote control (433Mhz) should be / is compatible with the new controller according to the operating instructions. It is cheaper to buy an OLED display remote control than A27 batteries. I use two old 1,2V Ni-MH... Thank You for the Video!
@carlosandrade60able6 ай бұрын
I just had one fitted today and I have the same interface, great video and very helpful. Thank you!
@richardhughes29886 ай бұрын
Cheers pal just got mine up and running in 10mins thanks to your tutorial 👍
@flybobbie14496 ай бұрын
Stare at the fan symbol, which way does it rotate? Then think it turns other way....and it does, weird.
@shaungrant52597 ай бұрын
Hi. I just ordered a replacement board and this controller, when I connect it I get the red circle, battery symbol and just three dots for voltage. Pressing any buttons doesn’t do anything, if I put the old controller on it works with the new board. Any ideas on this? I thought maybe it was in 24v, with the buttons not doing anything I am not able to check. Thanks
@2005mic7 ай бұрын
Birds and controllers are usually matched. Just use the controller that works
@shaungrant52596 ай бұрын
@@2005mic Thank you. The reason I ordered both, the old one is to dull to see.
@shaungrant52596 ай бұрын
@@2005mic Sorry to bother you again. I had another heater here with the new type controller as well, any ideas why it does the same? They power up but don’t show voltage and none of the buttons do anything, same again, the heater fired with an old controller. I changed the wiring loom to the brand new one that came with board and controller, exact same thing. Surely they both can’t be broken, is there a lock on them that you know off? Thanks again.
@2005mic6 ай бұрын
No lock that I know of.. a lot of people have complained about boards not working so probably you were unlucky to receive 2 dud ones