2/10 for helping your customers fit this system that you sold to them. For the sake of an extra minute or two you could have helped your customers to install this. Shame on you. The diagram that comes with the kit is pathetic at best.
@DWAIN613 ай бұрын
Tripods were very expensive when this was made.
@DWAIN613 ай бұрын
pound shop pliers
@DWAIN613 ай бұрын
It is about time that Elite, updated and improved these videos. I doubt very much if the they read the comments.
@DWAIN613 ай бұрын
I found this useful but could be a lot better. Have you ever been to a lecture or an in-house demonstration where they have background music. There is a reason for this. There should be more information about fitting a shelf as you cannot fit it after the assembly. You will need an extra 2 screws per glazing bar. The guy started to explain this but got bored. There is no mention of how you deal with having the bracket at the end of the side and how this needs to be fixed to the corner piece. 6/10
@DWAIN613 ай бұрын
3/10
@DWAIN613 ай бұрын
Have you ever been to a college lecture where there is background music? There is a reason for that.
@liamdarrington33102 жыл бұрын
Did you film this with a FUCKING POTATO??? Jesus Christ
@mikehopkins40402 жыл бұрын
Good video, easy to follow.
@mikehopkins40402 жыл бұрын
Not too bad but the camera work needs improving.
@nik19691003 жыл бұрын
At 15:30 I assume the corner plates are cut if you are mounting your greenhouse on a hard surface?
@jsof23 жыл бұрын
I know this was made around 6 years ago, but I so wanted it to be better than it turned out to be. There is some benefit in watching it, but it could have been considerably more useful if the camera work and video quality was better. Come on Elite - time for a reshoot?
@Adamace19723 жыл бұрын
Actually in the process of putting up the elite craftsman, the supplied instructions are really awful and it's a good job I came across these videos I've now got 3 sides up and about to attempt the door end which looks tricky as hell if I'm honest, wish me luck
@Saintathantwinpeaks3 жыл бұрын
Are you finished yet Adam?
@royniven23894 жыл бұрын
this video will be viewed several times, it is a helpful guide as i am a guy how usually throws instructions over my shoulder, sometimes to my detriment.
@royniven23894 жыл бұрын
An excellent demo video
@johnphillips25515 жыл бұрын
The instructions do not go far enough. There is no mention of the steps one must take to ensure the angles of the frame are correct. To be of real use, guidance on how to correct possible problems should have been included. The must do's and don'ts should have been touched upon.
@drippydarka5 жыл бұрын
Got the model with 2 small doors, no videos anywhere and the ends are completely different. Figured it out (also put the glass in first as per previous comment), but now got 6 pieces of plastic which nit sure what to do with.
@trevorcole4606 жыл бұрын
Thanks for the video! As I got a second hand 6x8 Elite Greenhouse it is not numbered, so not going to be that easy to workout. I would like to see a full video of putting one of these greenhouses up. Thanks for the effort of the video though.
@gesanners14177 жыл бұрын
This is going to be a 3 day job at this rate...the instructions are double dutch
@lostinfens7 жыл бұрын
This greenhouse is supplied with woefully inadequate instructions and this video does nothing but compound the problem. The door head is not placed as per video, and when joining side to rear/front it is virtually impossible without undoing half the bolts.
@auditts1008 жыл бұрын
I followed your video and hung the doors then found the glass will not go in so I had to take it apart again s you need to fit glass before you fit both posts together