I just did this and put everything back together to find out the air is stuck on defrost. So tired 😂

Helpful thanks

Thanks for the info - I have a 99 XJ. Perhaps I used too wide a zip-tie - mine wouldn't hold. The rod has ridges and they not threads - so a nut of any kind won't work. I ended up using a 1/4" wire clamp which is a u-bolt clamp with two nuts to tighten where you placed a zip -tie. So far - so good

Thank you 🙏

Is this in mckee ky ?

Excellent video! Thanks for posting it. BIG help and presented in a very easy to understand manner.

Where were you at during this video.

how can i leave the trunk open without killing the battery? i have a 2001 xj and cant find anything lol

O

We miss you man. Where are you nowadays

Hey I appreciate you being so thorough but if you didn't have a leak in the evaporator coil it was totally unnecessary to replace it. I understand the heater coil going bad because it's copper but the evaporator coil is aluminum and usually doesn't need replacing.

Hey buddy, haven’t heard from you in a while, hope all is well

Water leakage in the rear in my case came from the bolts of boot door hinges. Ride without liner and you see it

Saved me a lot of money👍

Thanks excellent advice replaced number seven and worked

What brand are the fender flares? Couldn’t really understand what you said, didn’t see them linked

What if it is installed entirely? Do you have to remove the C-clips on the axel?

This came up as soon as i opened youtube today. Really do miss your content buddy.

Nice job, my xj is my trapping rig!

You did not show how you fixed your rear seal could you explain your process ?

Thanks for the vid!! This helped me a ton

I like how you cut the zip tie at the cocksucker angle lol otherwise good video im sure this will help me with my situation

Wrong, wrong wrong!! That rod is threaded for a reason, it's supposed to turn! Just push that green clip on the bottom of that rod and push it to the left. The rod pops out. Then turn that rod to the right, two or three times. Push the rod back into the clip. Push the clip to the right and you are done.

Haven't seen any new videos, have you stopped doing overlanding trips?

🇸🇦🇸🇦🇸🇦👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍

What was your altitude when you were getting the better gas mileage? I noticed my mileage went up to 22 mpg from a more typical 18 mpg at sea level. My brother who is a pilot told me that it had more to do with the O2 sensors dialing back the fuel feed to balance for the thinner oxygen than any aerodynamic drag reduction, if that makes any sense.

Well reasoned, particularly enjoyed the gear you’ve selected and why. That’s why I’m curious of the type of gear you’ve chosen to Carry in the Plano boxes?

what a fkn nightmare

A little shocked you haven't upgraded the headlights to LED yet.. :)

How’s the spartan treating you now? Were you pretty hard on the Aussie locker? What size tires were you running?

Just a question? Would caulk tape work?

I believe those plastic pieces on side of evaporator hold an air filter in place.

Switch which side your heads on while sleeping and its much easier to enter and exit

Your caps are already marked from factory. There’s a vertical H and a horizontal H on the diff on each side. There’s the same markings as the caps.

Long time man. Miss you

some have coffee vending machines and some even have ice cream vending, picnic tables all over the place and even walking trails. if you could afford the gas you could go from rest area to rest area to live if you live in your vehicle.

Worked well for my 01 XJ. Turned out my handle wasn’t contacting the release arm at all in the closed position. Undid the clip at the bottom holding the threaded rod in place and threaded the whole arm in more until it was touching the handle. Now the hatch is smooth as butter🤌🏼

Never understand why they don't have a nut on there from factory

Mine has a bolt in it ???? Do I have a carrier that shouldn't be in my housing ?????

What do you do for income while on the road?

What make model is the bed rack?

Cool rig. I like the magnets and extra tie downs 🎉

Miss your videos.. You good? We need a update

Nice,thanks for the info I m working on two xj’s

I've seen another video of this but yours was way better. OMG!!!!!!

I’ve been looking for this video I just like to see what is in my head in real life so I can learn how to improve it for my version

Thank you for this I was truly breaking my head 👍

Thank you!!!!!

Looks like Switzerland: kzfaq.info/get/bejne/hc18dLVo29itYZc.html

Man, it's easy in a truck.