Garcia Linda Jones Laura Lopez Eric

I call the last mode kiss the window cause at 70 and you pull and let go you are kissing that window

Come mai nel video non si vede anche lo smontaggio della tavoletta wc thetford?

Registration is not the issue ..INSURING an HDT is the issue. ..insurance companies look at the vin ..it comes up as a commercial vehicle ..and they nail you in the rear end for the cost of a commercial vehicle policy .

How can I register a dime truck into a RV coach I would like to know please I’ll be waiting for your response thank you

Great 👍 information

Where did you the awning for the rv that shows on the beginning of the video when it’s raining??

After watching your video, and seeing how the flush ball valve mechanism works, it took me 5 minutes to fix mine. 1 loose screw was causing the valve to not rotate when I pressed the pedal. Tightened the screw and... boom, fixed! Thank you!

this guy thinks just like i do get it done no time for sittin around waiting for people to do it on there time no we need to get it movin now stay on it till the jobs done cuz if ya dont things sit things get lost things take way longer than it has to.

well its a provin fact that men love seeing women tread in men territory !! we all know when it comes to driving semi hdt its a guys job! its kool to see girls that dont need there hands held in everything and attractive. all my girl knows how to do is waste money complain and her famouse words i dont know how to do that...i hate that most of all.

Thank you

You forgot to put the new o ring the the ball flapper your going to have a leak

I would have left the top hat on and drilled through it and used smaller key

That was super helpful. I have the same exact problem. Not one RV repair guy will touch it. Thanks

You guys like to spend money. I do this all the time. Folks you don’t need to add to your frame!! Slide your fifth wheel all the way back. The fenders, it’s a good idea! The electrical, build it yourself or or buy one. They are cheap as heck! Not digging on this guy, but, he loves just spending!!! And he drives a Volvo…🙄 good luck to everyone, but good grief.

Thanks for the video, I don’t know if this has been said but after I removed the plug and found nothing in the pump I replaced the plug then blew through the drain hose and that dislodged whatever was holding the water from getting to the pump.

Donde puedo encontar las piezas?

this help me drain the washer, but when i turned my on still i get 2 red lights solid on and the power is flicking on and off very fast mine doesnt have a LED display its an Ariston-Avxl-129

VERY helpful!

That's why it's called the STEALERSHIP !

Well sir, I am obviously woefully late to viewing this video…, just bought one of these units.., and I cannot believe “Camco” has not yet remedied the potential issue with the wheel “cap-retrainer” coming off. As you said, “everything about this tote is great”…, yet “Camco” skimps on those wheel retainers. Your fix is awesome..! Thank you sir.

I don't get how texas is good for rvers as of right now they require you to inspect everything you tag with means every vehicle you tag has to be brought back and inspected that's a big under taking for some

Please do some more research into how to do this right and safely because if the ramp slips off the truck like I have seen so many videos of people loading four wheelers with ramps there's a guy from Canada setting these up to use pins on the ramps to secure to the truck bed also he uses a winch to pull the car on nice and slow

What is the point of adding a computer board to the light system I wired a dump truck one time to haul a backhoe trailer using a 7 flat rv pin connector it was as simple as making a 25 ft extension with male 7 round pin commercial plug on one end and a female 7 flat rv on the other not sure I would want to add a cpuboard one more thing to worry about and just extra cost near as I can tell

This was mountains easier than i expected. Thank you so much!

Is this shop available for hire to build another bed on an HDT?

Great save. Hope you guys are doing well.

great video again. Thank you

Love your content, and very informative. Thank you for sharing. Hope all is well with the Jones'.

Thanks for the video. I just made up something like you did.

We miss you...what the heck happened to you two? I need more videos from you!!

You should delete this video... it no longer applies. Mayby .ake one on switching it for the new brass one

Is the HDT still for sale?

wondering what ever happened you guys ok or took a different path

Oh, to have a work shop like that...

Great videos - lots of things to think about. One question: How has your emissions equipment been hanging on? I’m seriously considering a class 8 to pull our camper - but the replacement cost of the ‘One Box’ is outrageous. Do you know if the light engine load helps to lengthen its life? Any experience is greatly appreciated! Keep up the fine work!

Who insures this conversion? I can not find anyone.

Great job! I have to do mine once I find the parts.

howdy, how did you get your truck licensed as a rv hauler, please advise, and is there any length limit for overall length of the truck & trailer, thx

Traveling in sryle.😊

Doesn't hurt you have some knowledge.

Are you guys going to make more videos

You saved me a lot of $$$ Thank you so much ! I am not handy at all But i tried what you did and it worked😊

Thanks for the video. Have a leak near the pedal and will be replacing the Ayer valve. This helps me a lot.

Oh myyyyy. Drilling a heat treated frame. Last i checked thats a big no no.

Its been a year. Are yall still alive

Thank you for info cause I'm working on a 2017 ford f350 6.7 now cause has popping noise coming from air intake and I been researching all it can be. So far I found out be bent push rod, lifter, or rocker assembly and I'm not ready for this job 😳🙈😅😂🤣

Fanfreakintastic!!

Excellent video for a novice like me!😊

They fixed the issue..