Mine fauled after a few months, this is not an isolated incident. I reccomend you avoid them.

I use both depends what I’m using like my ryobi blue tooth little speaker that I love not going to be buying expensive battery for that nor the torch. I find I’m still using the cheaper batteries because I don’t care so much knocking them around. For the price difference 0ver the extra 10 min well worth it and if ryobi changed there batteries for some reason I would go back to Mikita or something else.

Excellent article, hated the loud background music!!!!!

honestly using cheap 40$ 580 8gb on solar would be the most viable option. it would pay itself off in less than a year even assuming you only run during daylight with no battery

These are great in power outages.

Hey mate. I can buy genuine 6ah 40v ryobi at the fleamarket for $60 a piece, open box though.

I still have about 30x or so 580-8G cards I should have sold, ( for that matter, also about 30x GTX 1070's also ), I have replaced them with 30 series cards, and a few 2080's which on certain coins still seem to out perform some 30 series cards. I had hoped one last up cycle would increase there value; foray, no joy there. The remaining option is to sell them as budget gaming cards since they can still run aproximately 12,000 class A game titles; or 60 the fps @ 1080p; when I used to run them in a gaming rig; I always ran two, (2) in crossfire mode; or the Geforce cards bridged. I also have about 30x RX5700 XT's that were doing well on Kawpow algo's. I am currently only running a few ASIC units & about 10x FPGA units; and a FLUX node via MCap; which for an undetermined reason; it bugs out every 40 days or so and had to be reset. Thanks for the video content. Peace

Great video you just earned a follower

Ryobi is junk too. You will be very lucky if you can reach 50 charge/discharge cycle. My four batteries are dead after 3 years. I used it for a trimmer and a mower, so only few times per year.

Luv the tools, batteries are absolute complete crap, why is it possible for a battery on the charger get to weak to charge ? Fin stupid

I have the simple approach of every time I buy one of the 40v tools I get the kit with battery included. It's usually 20 to 30 more than the bare tool buy I get the better battery for the money. Buying single batteries you might as well buy a random tool with it. It'll cost about the same.

Mine soon shuts off on hot days using the cord. change to battery and works fine.

Where do I find the serial number on the P2803 18V Chemical Sprayer

I purchased a Team group EX2 2GB SSD two years ago from Newegg. Last month it died (still under warranty) and I got an RMA number from them. It arrived two weeks ago, as confirmed by the USPS tracking number. Team Group apparently lost it and is now refusing to honor the warranty, claiming that their US affiliate has to confirm it's arrival, in spite of the fact that the USPS has clearly confirmed it. I reported this to Newegg and they refused to even contact them, claiming that Team Group has to first admit that they lost the drive, something they are refusing to do. I have never seen customer service quite this bad.

I purchased a Team group EX2 2GB SSD two years ago from Newegg. Last month it died (still under warranty) and I got an RMA number from them. It arrived two weeks ago, as confirmed by the USPS tracking number. Team Group apparently lost it and is now refusing to honor the warranty, claiming that their US affiliate has to confirm it's arrival, in spite of the fact that the USPS has clearly confirmed it. I reported this to Newegg and they refused to even contact them, claiming that Team Group has to first admit that they lost the drive, something they are refusing to do. I have never seen customer service quite this bad.

If you pay 1/4 the price expect half the capacity. An example of you get what you pay for.

Please help me How much Can I make every day with RTX 4070 🙏🙏 I am a begginer pls help

Thank you for this video. The Walmart listing does mention "Maximum Air Volume: 8200 CFM" in the "Specifications" section, along with other information, though I too am suspicious of tall claims on most of these products. Interestingly, Walmart mentions the weight as 30 lb whereas Amazon at 32.4 lb - I wonder if there's a difference in material or the motor, despite the product images looking identical. Or perhaps even the weight has to be taken with a grain of salt, adding or subtracting ~5% to the listed amount. I am considering purchasing a fan for home use - high-intensity VR gaming - and am considering these fans. How "focused" (vs diffused) would you say the airflow is? Would one feel a good amount of airflow, say at a distance of 20 feet from the fan? My Hurricane box fan (with a 4 inch Merv 13 filter taped to its back) can barely be felt at anything over 10 feet. 1. Hyper Tough 24" DC Drum Fan - $124 now; 0.16 HP; max CFM claimed 8200; probably too big and unwieldy for home use 2. Hyper Tough 20" DC Drum Fan - $88 now; 0.13 HP; max CFM claimed 6200; the equivalent iLiving one on Amazon and Home Depot claims a max CFM of 5700 3. Hyper Tough 20" AC Drum Fan - $69 now; 0.25 HP; max CFM claimed 7000; the equivalent HiCFM one on Amazon and Home Depot claims a max CFM of 6300; has a few reviews on KZfaq which attest to its efficacy 4. Vornado or Dreo DC "air circulator" - in the $100 range; max CFM in the 1000 - 1500 range, possibly true; smaller; quieter; claim to focus airflow up to 100 feet (due to blade and grill design)

So I just bought it cuz here where I live (Puerto Rico) we tend to get a lot of power outages and plus now we are entering Hurricane season so yeah I think it's alright for my current situation

hey bro can u just tell me which coin is the most profitable for me right now I am having the same card with 16GB Vram variant and also having 32gb ram too . I am new to mining so if u can just suggest me some good software and coin it will be really helpful to me ! Thanks in advance

i bought a knockoff 18v 4ah Ryobi few years ago and had very good luck with it. I bought a pair about 2 months ago from Amazon (DTK brand) and while both ran my drill one would not recharge so back they went. I ordered a different brand pair from Amazon and neither one of these would accept a charge from my Ryobi charger. i Know the charger is good but 3 of the 4 4ah cells would not recharge and were labeled as bad by the Ryobi charger. I then found a pair of genuine Ryobi 4ah batteries and those ran the drill and accepted a recharge. Although the knockoff cels were a different brand you could tell they were made by the same outfit - a 75% failure rate tells my that outfit does not know what they are doing. I'd be very leery about knockoff ryobi batteries. I doubt the knockoffs are using the same quality cells so even if they do work they will npt last as long.

🙌🏽🙌🏽🙏🏽🙏🏽🙏🏽

Running 4 580’s I got at $50 a piece. UnMineable and PEPE before the 1000% spike. It was a gamble all the way round, but paid off.

Excellent comparison. Thank you for this.

Owned the Generic ones for several years now, still good, When you can get 4 for the price of one, you can run multiple tools. Maybe around 25% per battery but when you get 75% more batterys, it is a real no-brainer, the First battery offers 75% of the original, but then you have 75% x4 = 300% more for the same price, also the most important point, your still using the tool when the real battery has run out and charging, you still have a battery or two ready to go.

June 1, 2024: A RYOBI 40 volt, 4 amp hour battery costs $180 vs a knockoff 40 volt, 6 amp hour battery that costs $60 with similar run times. Perhaps the biggest Thief is RYOBI and how they stick it to their Consumers?

I bought generic for my Ryobi tools and find they are MUCH better. To be fair, the 18v, 1.5 amp batteries that came with the tools, I replaced with 18V , 3 amp generic! Wowzer what an improvement.

Very well explained, thanks mate

Especially since FiroPow made a substantial price jump and they are giving to the top hash rate miners a special financial reward a 4060 would be the worst GPU for any Kapow Algorithm, maybe a 4060 ti for Neoxa, 4070 Super for Ravencoin, CloreAI 4080 Super or AMD 7900xtx & NeurAI 4060 ti / 4070 Super and make adjustments as all Kapow algorithms will increase in Value especially from August on, bc that is how it was in 2022

The creator of this video did a very good job, and what a very pleasant voice. I am a pastor and educator, and I really liked the entire video. Thank you.

I have one of the 18v 9amp hour one from Amazon I just use it to run a a 12v cooler it runing it for about 7 hours....so I don't wast my name brand ones....

I still use them, but i was able to run the 4GB rx580 saphire nitro version. The big issue with 4GB cards is you cannot mine even RVN now because of the dag file size. I opted out o mine CLORE using simplemining with teamredminer and getting 14 mhs per card stable. One rig with 13 cards can return about 2.5 to 3$ a day (about 14 clore at today price). If electricity costs are not a concern you can squeeze a little bit out of the RX580 4GB cards yet.

The fact it has an EXTERNAL adaptor now is simply a cost cutting measure. The previous fans that could plug into an extension cord had an internal rectifier. All Ryobi fans that can run on a battery are DC only fans. This fan is also not brushless so it will eventually stop working when the brushes wear out. Probably right after the three year warranty is up. The 40V model has a brushless motor. This should be much more reliable, but if a person has a sizeable investment in 18V tools and batteries this isn’t a great path either. The best fan in their lineup is the smaller misting type fans. They move decent air for a personal/kids sports team type device. They are decently priced when on sale and run for a long time on high with a 4ah battery, If the 14v fan was $79-99 then it would be a better investment. 55w on high isn’t really very efficient. Many box fans that are 20” can do that or better and move MORE air. Most of those box fans are going to cost under $40. Battery option is the ONLY feature that makes this fan attractive.

LOVE RYOBI SYSTEM ,, But i go with HYPERTOUGH DC MOTOR FAN,, 8400 cfm , variable speed ,,110V only draws 112 watts on max i run IT on my RYOBI 150 WATT INVERTER ,, OR GET GENERIC 200 WATT INVERTER ON EBAY FOR RYOBI ,, ITS A 24 INCH FAN WITH WHEELS // OR THEY ALSO HAVE 20 INCH DC MOTOR FAN ITS ALSO VERIABLE SPEED ,//// BEST FANS OUT THERE FOR USE ,, PS A RYOBI FAN IS ONLY ABOUT 3000 CFM 3400 ON MAX ,, HYPERTOUGH FANS KICKS ITS ,,,LOL,LOL PS HYPERTOUGH 24 INCH ON LOW DRAWS 12 TO 14 WATTS

Have you tried the TRM for ALPH? What's your thoughts?

thanks for number. Just bought a 4060 to remplace my buggy 5700xt. But I think it just better to not mine with those unless starting or very desperate :)

I am currently running (8) 580s to unmineable. Getting paid out in different coins.

Home Depot pricing may not be the best to use for comparing batteries. A Ryobi 4 ah battery (factory blem; aka brand new) from Direct Tools Outlet is under $26. So the Genuine Ryobi battery is $2 less than the underperforming generic battery.

is the card still working

Fuck u miners

I just found 3 of my old ones

Is the SSD still working fine?

The 4070 ti is only outstanding at mining Kapow but beeds higher overclocks to achieve over 40 MH/S. Second best is Alephium there with tge correct Overclocks you can achieve up to 2 GH/S

Luck you, got natural cooling

Thx

Great video I still have 7 of these going barely breaking even but was such a great card in the Ethereum days prob gonna slowly replace them and sell in the next bull market when gpu prices skyrocket again

I have about 20 Battiers myself over here in Canada. I prefer the genuine Ryobi Batteries over the generic ones. Just for safe of mind sake. And knowing that they will work right. And when they have specials for the batteries I ten to go for those as well especially the two Packs.

E100 sounds like a German Super Heavy tank

Im curious whst the runtime in the blower was wity the 4ah? Also was the blower set at the hightest speed?

250GB & 500GB.drives will soon be forgotten, except by Apple who will continue to solder them to the board of all flagship M3 laptops for next 10 years. 😂