How much total quantity liters ? 3.7 or 4.5 liter ( honda civic 2018 2.0 engine cvt transmiision ) sir plz assist me thx

This title is misleading..you DID NOT do a flush and the fluids you are using are inferior.

amazing video. you are a great presenter!

How many miles did you have on this civic before you needed to replace the water pump?

When you changed the rear brakes did you have to reset parking brake dashboard light indicator? We changed the brakes on my Acura MDX 2017, now all the dashboard lights for the brakes and parking are lit up?

Nice brother thank you

Thanks

For anyone reading this procedure two years later, the fluid should be slowly dripping out of the overflow when the fluid temperature is 40°F or less. YOU SHOULD NOT check the level after the fluid has warmed up!!!! There is no need to run the engine until it reaches operating temperature, and the cooling fan turns on. Many DIYers get this wrong.

Will this be the same process for a 2018 Honda Accord?

super yummmyyy

wow!!!!Sana all na lng

INteresting...on the Si model, you don't need to remove the airbox to remove the fill plug.

How much engine oil did you use? Also, do you need to add a new oil filter when changing the oil?

Thank you vid you are the best

Thanks for sharing! We also have a 3 series convertible that has plenty of how to's on youTube. Our 2006 s-type V6 is my favorite car of many since 1975 but NOT a favorite to work on. A very powerful automatic carwash blew water on the engine frying the coil seats so getting that mess straightened out, I went by the book of first step removing the wiper arm to get at the back of the intake manifold wires to disconnect them for removal. It is probably possible to do it, blind feel with little hands, but not the first unknowing time. I'm sure others will appreciate any more s-type videos you produce.

Thanks for the video.

Is this the same transmission as the 2014 MDX has?

The arrow on the filter or air flow indicator points down. You installed the filter upside down.

U need some Eibachs bro It will actually ride better too, which blew my mind… Just did mine yesterday it doesn’t even look lowered it just looks unlifted 😂

.......can you work on my 2004 E51 Elgrand come time? I live in North Delta

How to reset my 2008 camry acv40 front parking sensor?

Are you sure you're not bending the pulley by doing that? service manual specifies that by creating force from the outside of the pulley instead of the holes near the axis will bend it, and this slight minimal distortion of the pulley will create vibrations that, as the manual says, will damage the gearbox

You saved me so much money!!!!!

Hey, shout out to say great video fully explaining how to replace the actuator. I am not mechanically inclined and don't enjoy working with plastic parts I usually break. Not to mention I hate working in confined spaces. My son and I got through the replacement without a hitch. We also enjoy your calm demeanor and verbal explanations. Thanks you so much.

What cleaner did you use to spray just curious?

Hi, thanks for the video! You said Left/Right doesn't matter, are they identical parts then? I have a torn inner cv boot on that same assembly and can only find a used left side. Would you recommend replacing the whole cv axle or would a boot repair kit be okay? Thanks again!

Leak is probably from the cam sensor adjuster magnets at the very front of the engine. The oil is forced through the harness and travels everywhere even to the oxygen sensor and eventually up again to the ECU!

You got all the 4’s and 2’s on your display. Luck is with you 🤙

Special procedure to disable this mode? Or just turn the car off and it’s fine or repeat procedure backwards or something?

Absolutely the best video online for this service. Cheers 🥂 mate!

Torque the bolt to 30 ft. Lbs as it is safer. Also remixing and installing manually the 4 screws is better. Cover is a little PIA, but necessary

I’ve seen other video where they fill up the transmission fluid through another opening closer to the front, which one do we use?

What if my screen if cracked do I have to replace the whole thing

You know there’s a bleed method that Honda says to perform after transmission fluid change, I’m an Independent Repair Shop and I hook up the Autel and perform this after. None of the videos show any DIY’ers performing this

If he had been installing a Lexus OEM cabin filter in the video then yes, the filter should be installed with the arrow on the filter pointing up. However, he’s clearly using an after-market filter as the arrow on the filter has “air flow” written beside it. Therefore he installed the filter upside-down in the video as the arrow should be pointing downward, as that’s the direction of the air flow. Other than that, the video is helpful in that it clearly shows the location of the cabin filter, how to get to it, and how to replace it.

I'd like to thank you for your efforts for making this video,today l had my first issue with my elgrand, l put In new struts and l noticed a cracked boot and l thought l could just put plastic and tape it,l got into my vehicle and it was shaking and l parked and l looked under the driver's side and the boot that is at the opposite of the motor was twisted,lts been shaking alot also when l brake,l guess it's time to change that axle

Why is the music soooi loud!!

What size crush washers for transmission plug and overfill plug??

Any idea how much the sensor part cost? Thanks

Thanks

What about P0842 Transmission Fluid Pressure Sensor/Switch A Circuit

i have a 2018 - i don't go to Honda for nothing because they are crazy expensive. i had my fluid drained and filled at 73k miles. i am not at 92k miles. how often should i change the ATF? I spoke with the shop that did it, they recommend every 60k per guidelines. i hear some people say 30k miles.

Is it the same procedure with the 2013 acrua ilx ?

I can’t get the FKING CAP off no matter what!!

Hi mate why do you take the squeelers off the outer pads, tia

This helps this is something that I was just curious about. I just got my Subaru Impreza hatchback yesterday thanks dude.

What mm spacer did you install?

Man this video sucks. Can't see anything and you failed to mention the year make model and engine size. WHAT DA!

Thank you

Thanks so much. You saved the day.