How i can boost DRL to Full brightness with Low beam and high beam ? Another question how i can make Front Turn signal stay always on with DRL and all lights? My car is Frod Bronco Sport First edition 2021

Thank you!

Your drive by's were not the same. If you are going to do a comparison make each the same. Pulling into the driveway with the Delkevic is not the same as driving by with the stock exhaust.????????

Have you found out how to change passing blinkers from 3 to 5? Ive tried changing 724-01-01, but that doesn't affect it.

Looking to turn off the door code keyless entry on an Explorer ST without having to take the door apart- any idea if this is available through the Forscan app

How far thry stick out? I got a 2018, looking at 30 offset for flush look

Have a 21 would like to do this not sure if this fitment works? What a PIA to change a bulb! Or on the case upgrade the entire light assembly. Where does the line start? When can I drop by so you can make sure I don’t screw this up😂

What was that last one - boost vacuum ? Good video , thank you. And what is the reason having fogs On with h.beams ? Them fogs dont do squat anyway.

The reason it wouldn't disconnect is because you didn't stop the service procedure 😊 when you look at your video and you are trying to disconnect it shows that it's still executing the service procedure.

Hi 👋 I press on clear log in fordscan when I check my ford ST 2022 And now that DTC don't appear How I fixed that 😢

excellent!

Why no install video? You show taking out a bolt, but nothing else and no install of the new shackles!

I like the rack. I'm going to get one !

That neighbor now watching you. lol

I have a 2023 klx 300 and was wondering on the pavement does your front tire pull you all over the place I feel like my tire is defective?

I returned mine. It caused a vibration while driving at about 20-30 mph. Sad cause it made the truck look so good haha

Great sound! Glad i got to watch this

How’s the ride quality?

very nice! any drone inside cab?

Did the exhaust cause any damage to the turn signal?

How's the shock holding up a year later? From initial comments, didn't seem this was a noticeable upgrade...or did you notice improvement? Given the OEM damper is ~$60, would you recommend the Fox, or just stay with OEM?

Did you have to put on spacers by chance? I’m trying to hug some for my 22 f150 but the website niche tells me only 20 fit and that I need spacers for the 22

That’s only a 1 inch drop

looking to get one of these or the 300sm. can i just buy a set of street wheels and tires and just do a swap anytime i wasnt doing off road riding?

It just drop. 1 in

Do tires need to be in the air or can this be installed with them on the ground?

When your driving does it feel the same or different ?

Nice bro

Мощная тачка👍👍👍

22 plastic plastic n tin.. n a million sensors..that if one broke or quit... I'd still have plastic n tin... N a big bill..cause UR ass wouldn't know how to fix ur expensive .... Crap

Part of the perks 👍🏼

was possible to fit the h7 led lights?

Did it stop the wobble. I run 35/12.50/20 stock wheels and I was looking at this and the dual one from icon.

I like the stock exhaust; don't fix what ain't broken. It's stainless steel and high quality and factory tuned for the bike.

hey man i got the same bike and i got a amazon slip on but it never came with the middle pipe, assuming u need a muffler that comes with the middle pipe right??

Since you've had the Delkevic on for a while curious to hear how the rear turn signal is holding up. There has been some reports (and pictures) of the turn signal melting from the heat of the exhaust...Thanks!

Only dropped it 1". Went from 38 1/4" to 37 1/4".

Did you do the tuner ? To or just the slip on

Yoy not change shocks

I need and install guide I bought them used and I wanna wired them up correctly

Where’s the install video ?

Thanks for the video, I just purchased the 9", this will help me out a lot. Where did you place the silicone gel?

Regalame ese escape que le sacaste a tu moto el original

Any need for an alignment after installing this?

A nice installation video for the exhaust. I want to install a pipe that is not very loud but still has performance. Would you happen to have any meaurements on the sound level coming from the exhaust, like db readings at different rpms? I currently have a FMF Q4, with KDX snorkel, Twin Air filter and EJK which gives me 2.5 hp more than stock. I would like a quieter slip on exhaust. I have the same PMR rear rack, but also the side racks to protect the battery/radiator fill bottle when side luggage is installed. It is more work if you have to remove the seat, so plan ahead.

is the exhaust legal

Hello friend, can you tell me the link please for me to buy it, thank you good video

Good job, thanks for the video. Did it help the stability much over factory? Am running 38’s on a 6” lift. Currently have a dual stabilizer setup but am contemplating adding this.

Enjoyed the vid, fellow Floridian. How is the bike on the turnpike/highways/thruways, as far as comfort and capability? It would appear that panniers would melt on the exhaust, no?

With the new Kawasaki rack. Is it necessary to remove rack when remove seat and/or side panels?) Enjoyed your video, thanks.