@@DomZone123 yes sir

@@JohnUyArts paano po master??

@@DomZone123 need spacers sir

@@joekool9601 ohhh i see, i think there is a spring that pushes them apart images.app.goo.gl/mwmJhStSfFuzbZgj6

@@JohnUyArts yes yo are right there’s a spring and a little rod that goes on top of spring , I lost the spring but now found it thank you

@@indeedinteresting2156 yes basta good pa air spring or coil spring

@@JohnUyArts Thanks sa reply sir. Sira rin kasi yung aking epicon fork cartridge, may tagas ng oil at wala ng pressure. Nag order ako ng cartridge pero di pa dumating. Bike na bike na ako HAHA.

@@indeedinteresting2156 disposable kasi yan, kaya bili bago cartridge

@@JohnUyArts Oo sir. Inassemble ko nalang ulit ang fork tsaka ginamit. Hinihintay ko pa yung bagong cartridge na dumating para ma install ko na.

Same lang sir

sorry I only have time lapse

Lazada or Shopee

Well this is just unboxing. To answer your question, i have used this many times now, for automobile its good enough (⭐⭐⭐🌑🌑). For household use, its a ⭐⭐🌑🌑🌑 Yes it can clean, but just enough power to suck dirt, its more like a 1/4 power of a corded vacuum

@@JohnUyArts That doesn't sound like much power.

Yes I did this at home, with just an ordinary soldering iron, its a crappy one actually.

around 5 to 10minutes

also depends on what grit is used 😀

Im sorry i havent found any time for that :( I am mostly doing things for a living, its difficult in our place

WNew or Bangood

Yes no problem at all, it also makes the fork stiffer and stronger even if the improvement is small

Yes it is used to drill ceramic and porcelain tiles but use at low rpm like 400rpm, best if used with water

yes you can have it fixed in your local electronics shop

random orbit sanders are design for finishing works. the 10,000 rpm is referring to the orbits (the tiny circular motion that causes the main sanding action) not the rotation of the pad (the slow rotation that is trying to remove the orbital marks during sanding). when there is no speed control, the sander is powerful enough. but with speed control, the lower speeds are almost powerless unless you use fine grits on those speeds. the reason is the universal motors dont have strong torque at low speeds due to the variable voltage regulator used as speed control, universal motors perform poorly on voltages below the initial design of the coils. have you tried cordless brushless motors? they perform really well even with low speeds because they are current controlled which increases power during loads at lower speeds.

Thank for explaining, currently I'm using corded sender, but me already placed order for GEX185Li, i preferred cordless sender all because of cordless sender are more convenient to work. Once received my GEX185Li I'll compare with my current corded sender.

Try lazada

It is brushless, the electronics takes up more space inside, vs the older model which only houses a dc motor

1619P11715

Dont worry I normally dont do things that way 😊

@@JohnUyArts Ok, glade to hear that.

Synthetic Fork oil

140 sit

Around 15k to 25k sir

600mm or 650mm ata sir, need to check pa

Just transfer the pin sir away from the end