Thank you for that tip on cleaning the hot and cold hoses !

Very helpful. Thank you

F07

my friend thank you very much for posting this video, you saved me a lot of money in a mechanic, I did everything you taught and installed the part and it worked correctly, God bless you

Thank you! Very useful indeed. Only problem is that I can get the turbine filter off to clean it. I tried the 18mm and it was too large and strangely no other ratchet piece fit. Tried a shifter but could not get it to budge. Do I need to replace pressure before removal. Any tips would be useful.

Great video. Saved me lots of money. I ordered the part from ofu-part. Great price. Instructions were excellent. Saved me a $1000.

How to avoid this burning problem after replacing the board? what we have to maintain and do a regular check up?

Anyone ever get a code 3 . Fixed all of these sensors... I don't know what next. It says its a flue air pressure switch. Changed it. Still have code. Pls help

And don't forget to clear the codes second button you press stay in for 5 to 10 seconds that will clear the codes for the next repair that code is not there any more /that way if anything happens in the future that code is clear and don't get confused thinking its the same problem/ 25 years experience appliances good luck

Repair clinic is fine, but you can find the part cheaper on Amazon with free shipping.

There is no way that a clogged inlet could cause that control board to burn out. No way.

any idea on how much the new board may be? is it worth repairing?

That code, F06 and E01, like most of these videos show, means that the MCU is no longer talking to the CCU. That could be one of three things. MCU--most likely. CCU-- less likely. The wiring between them--- least of all likely. I know that Futures Trading was very kind to put out this video. All good advice, but there is a surefire way to determine if it is the MCU. Remove the MCU, and then remove the motherboard from the white housing. Only three clips hold it in place. You will most likely see a small burn mark on the housing which will line up with a damaged portion of the MCU motherboard. If you see the burn mark, it's the MCU.

Hello, Where did you get the replacement board?

Hola Luis, eres tu el que ha comentado alguna vez en el chat en directo de TradingCero??

Thanks. Id missed that clip and was stumped on how it came out. Appreciate the video.

i have a baxi luna 310 combo , while im in the shower the water keeps going from hot to cold ,,, and back to hot and cold . at the unit it appears to start then run for 30 seconds then stop for 15 seconds then start again ,, any idea how i can fix this ?

can the boiler stands for long time if I use it as water heater for kitchen and shower

Thanks I appreciate that it’s an awesome 👏

Thank you very much. U saved me hundred$. 👊😎

I need to replace mines any ideals

Hi I have a baxi luna comfort 310 fi, I have to use bathroom faucet and shower to get dhw . Wheres the diverter valve to change diagram. ?

Hellooooo. I have a BAXI LUNA 310. How i can fixed???? The boiler does not stop with the heat, it is working all the time. We can not control it with the thermostat. Please help me with that. Thanks for the attention

yes protesting for the rights of 10% of the Regulus jews not to go to the army . its okay for them to take benfits .pay no taxs and disregard there own religus dogma........... but sure make a bs thumb nail saying for jewish rights. whole country's Jewish most Regulus support isreal. im assuming you go to all the anti isreal pro tests?like putting on a yammukia to protest isreal????

how do you learn trading ? it too difficult for me to find a mentor :/ email me [email protected]

Good job Tatto.