Ghetto

How do I get my monitor to print? I’m hitting record and the paper is blank? 😮

How can i check the whole history ?

Could you plz show if you can set the parameters of light intensity and co2 insufflator pressure and flow on the monitor or not?

Does it have power backup

For the laps, it's important to use an insulation test prior to use. Over time, the insulation may wear out. This can harm the patient.

It is possible to connect this monitor on ct scan ? please show me the specific cable!!!

Thanks for this video! I didn't know it had a smoke evacuator...lol

Did you find the solution for this error code 001 ? 

I'm anesthetic student

Продажа ест stryker 1588

The orientation of the patient circuit does matter. The filter should be on the expiratory port of the machine. The inspiratory filter for the patient is on the other end. There's no need to filter the inspiratory breath twice.

If you’re going to demonstrate a product, please do not instruct your audience not to utilize the Sensory function. It is up to the provider, not the Rep, to decide whether the Sensory function is necessary. It is on there for a reason., and many providers still do use it. While it can be assumed the Sensory interface operates identically to the Motor interface, you should say as much instead of teaching your audience to skip it, please. The sensory function is very useful, as the more accurate the needle placement, the lower the Sensory voltage should be. 👍🏻

Is the stryker cable sterilizable?

The microphone was far from you, just to comment on the sound otherwise it's interesting, Thanks!

Denton texas you are way too much.

Amazing video! Very informative for a new surgical tech !

i actually came for the pre operative check that was skipped 😢

Excellent!!!

Nice in-service!

Excellent sir

Could you do a Calibration of Flow Sensors on the Setup mode?

Interesting😃

Get to the point… why are we using it and why did you need all this time to explain it