How did you put the clip on bottom 12:30 in the vid
@artur1985558 ай бұрын
is it possible to fit smaller filter ? I have seen this vacum and its greate but the filter is way too big for that size of vaccum and it takes too much space inside the tube
@LittleShedBigIdeas8 ай бұрын
To be honest I don’t know. I have just replaced my filter but I went like for like.
@thedjdominator9 ай бұрын
you don't have a wall anywhere where you could have tested the wire detection?
@Fraggman66610 ай бұрын
I have this tool, and it’s sadly useless…
@jellybean849511 ай бұрын
Hi, does this have a depth stop by any chance?
@user-zq3dd8bc4t11 ай бұрын
My old Hoover wet and dry just packed up , need a replacement as powerful , the hoover would pick up nails screws and reasonable size debris , plaster etc. Do you reckon this is powerful enough to do same job ?
@LittleShedBigIdeas11 ай бұрын
I’ve not had any complaints about it, to be honest. My best advise would be to check the power rating vs your older machine.
@fredkemkers9434 Жыл бұрын
This device can be fine adjusted on the angle settings. Just loosen the three torx screws from the angle scale, use an 90 degree carpenter square, set it and tighten the three screws again, done.
@aaazzz1331 Жыл бұрын
Hi , what is the maximum thickness of wood that it will cut through ?
@LittleShedBigIdeas Жыл бұрын
Hi, if my memory is correct about 170mm.
@fatimaasadi7261 Жыл бұрын
Useless video !
@88Frank Жыл бұрын
I find this tool utter dogshit! So inaccurate for me
@MrHeppinstall Жыл бұрын
Looks brilliant, especially compared to how it looked to begin with!
@PhilsWorkshop1953 Жыл бұрын
Happy moving day and yes family will always come first mind how you go
@p.kofmehl715 Жыл бұрын
One of the best reviews. Short, compact and with practical informations. Keep it up
@essentialhandyman Жыл бұрын
Living in a flip with 3 kids? You’re a brave man. Best of luck for the move.
@LittleShedBigIdeas Жыл бұрын
Is a fine line between bravery and stupidity!
@LTWCarpentry Жыл бұрын
Awesome buddy, would be good to see some more stuff your end. Where are you moving to mate ? I’ve just moved to great totham
@LittleShedBigIdeas Жыл бұрын
What Great Totham! That’s close. Did I know you were local to me?
@LTWCarpentry Жыл бұрын
@@LittleShedBigIdeas I think we must of done as we have had a sticker swap at some point but we must have forgotten 😂
@LittleShedBigIdeas Жыл бұрын
We should go for a pint sometime.
@LTWCarpentry Жыл бұрын
@@LittleShedBigIdeas always up for a pint, let me know where you on private message (Instagram) and we can sort something out
@Mojothepyrut Жыл бұрын
Where for £200
@LittleShedBigIdeas Жыл бұрын
I think Screwfix of all places.
@graemeyoung3776 Жыл бұрын
How do you change the blade??
@LittleShedBigIdeas Жыл бұрын
There is a small tool. Much like an angle grinder.
@samanthapaisley6436 Жыл бұрын
Why didn't you secure the two base pieces together
@LittleShedBigIdeas Жыл бұрын
Honest answer is I don't know. But it should be fine as there are lots else where.
@webby0779 Жыл бұрын
Quick question , do you recommend it please.
@LittleShedBigIdeas Жыл бұрын
If you remember it’s a vacuum cleaner and not a dust extraction system. Then yes. I’ve been very happy with mine. It’s been abused and come out fighting each time. The attachments could be better but the main unit has worked well for me. I did do a follow up review video in case you haven’t seen it yet.
@webby0779 Жыл бұрын
@@LittleShedBigIdeas yes ive just seen that video thanks. I only want to use it in conjunction with my plunge saw really so would ask if you feel it would be worth buying for that reason.
@LittleShedBigIdeas Жыл бұрын
Yeah I would say it would work with that. I used it with a sander and worked well.
@webby0779 Жыл бұрын
@@LittleShedBigIdeas Brilliant, and thanks for taking the time to reply 👍
@laurittapecina1099 Жыл бұрын
Can clean sofa wet with this vacuum
@LittleShedBigIdeas Жыл бұрын
Sadly not. The wrong type of wet vac.
@rjtalha9605 Жыл бұрын
Hi, what's the purpose of that black foam sleeve? Can I use the vacuum without that foam sleeve for dry vacuum?
@LittleShedBigIdeas Жыл бұрын
Hi. Yep 100%. I’ve used mine for wet and dry and never added it on.
@stellateddy4078 Жыл бұрын
What a totally crap video. What was the point of this? Watching you lut something together with no commentary as to what you were doing?
@LittleShedBigIdeas Жыл бұрын
Yeah, who would imagine that from an unboxing video!
@mbaabugri537 Жыл бұрын
Good morning sir I want p.v.c water pipe detector
@snappyfish Жыл бұрын
Just doing my bathroom but wanted to ask why you don like electric showerS?
@LittleShedBigIdeas Жыл бұрын
I just think they look crap. This one does anyway. Plus the hotter you want the water the lower the pressure.
@leechurchill5182 Жыл бұрын
Great review..do you know whats the maximum size skirting boards i could cut standing up against the wall? Cheers
@LittleShedBigIdeas Жыл бұрын
Do you mean depth of cut?
@leechurchill5182 Жыл бұрын
@@LittleShedBigIdeas not sure im new to all this and still learning lol I've bought a gauge to work out mitre cuts ( angles ) and when ive seen videos of cutting say 46 degree angles they normally stand the skirting up against the back. My boards are tall and not sure what size the saw would accept.
@LittleShedBigIdeas Жыл бұрын
Ah I get what you mean. I’ll have to have a measure.
this detector never works for me. giving wrong results all the time.
@Kevin_Beach2 жыл бұрын
I want to gather a number of switches together from adjacent spaces, without having to rewire any of them. Can the receiver be used to replace the switching gear in a traditional light switch, so that the kinetic light switch can be used as just a repositioned switch?
@LittleShedBigIdeas2 жыл бұрын
I believe so yes. There 99% sure there is a video on KZfaq where someone did exactly that.
@mriduminocha31222 жыл бұрын
*Just completed a big trim project on my house **MyBest.Tools** Performed very well. Also appreciate how easy it is to move, set up and store with the integrated stand. No more cutting wood on my knees.*
@SolarizeYourLife2 жыл бұрын
I like the units that have a smart receiver...but this unit can save a lot of labor and needless wiring... I wish I knew of this when I had to rewire my new house...the bastard electrician never wired several switches that I had in the contract...
@LittleShedBigIdeas2 жыл бұрын
I really do wonder why this isn’t a more used method for installs now. So much quicker and easier.
@jamesgaunt16272 жыл бұрын
What are the dimensions when stacked for storage? I need it to fit in a tough system 2.0 box
@LittleShedBigIdeas2 жыл бұрын
I’m not sure on the exact measurements but I’m pretty sure it won’t fit. It’s small but bloody heavy so not sure you’d want to move that much anyway.
@essentialhandyman2 жыл бұрын
Coming along nicely. Tip for the wall with lots of holes due to old curtain poles. Screw a length of ex 3x1 on the wall, as a pelmet backer. You can then screw into it with whatever curtains or blinds you want to fix. Do it before painting, so you can paint it the same colour as the walls.
@Yourenglish-nd2vq2 жыл бұрын
Thank you for the video. Here is what I want to ask you about. Can I just use it without the dust bag??
@LittleShedBigIdeas2 жыл бұрын
Hi. I have never used it with a dust bag. I have an update video coming soon about the vac so don’t forget to check that out.
@SteveMonk19562 жыл бұрын
That will keep you busy :-)
@LittleShedBigIdeas2 жыл бұрын
Ha. Yeah just a bit. Sadly the shed is a long way down the to do list as well.
@FamilyHomeProject2 жыл бұрын
Lots of jobs, can't wait to see what you guys do! its going to look great 😊😊
@mistevious2 жыл бұрын
Good ideas but sorry too much talk.
@LittleShedBigIdeas2 жыл бұрын
Charlie Chaplin fan?
@JiggsysShed2 жыл бұрын
All the best with the move and enjoy moving into a new workshop space.
@SteveMonk19562 жыл бұрын
Major project you have going on there, I look forward to seeing your progress and wish you luck. Great to see you back too.👍
@LittleShedBigIdeas2 жыл бұрын
Cheers Steve. Feel like this has been a long time coming!
@essentialhandyman2 жыл бұрын
Looks a bit similar to my house. What part of the UK are you in?
@LTWCarpentry2 жыл бұрын
Hi mate, you can dot and dab that wall out in the cupboard, that will get the levels right then plaster.
@LittleShedBigIdeas2 жыл бұрын
Thanks for the advice. Appreciate it.
@WeekendShedHead2 жыл бұрын
Congratulations on your purchase, Great insight into your project! Look forward to your progress , best of luck , cheers Rob 👍
@LittleShedBigIdeas2 жыл бұрын
Cheers Rob. Currently feels more like a headache then a project. 😜
@WeekendShedHead2 жыл бұрын
@@LittleShedBigIdeas 😂 you’ll get there pal.. that’s why it’s good to video, and look back when it’s done 👍
@FamilyHomeProject2 жыл бұрын
Excited to see what you do and follow along 🙌
@essentialhandyman2 жыл бұрын
Make sure you get the artex tested for asbestos.
@LittleShedBigIdeas2 жыл бұрын
Don’t even get me started on that one!
@MrHeppinstall2 жыл бұрын
Good luck buddy :)
@LittleShedBigIdeas2 жыл бұрын
Cheers mate….. you know you’re going to help my, right! Got to get you involved somehow. It’s not a house move without you.
@SteveMonk19562 жыл бұрын
Good Luck in your new adventures, hopefully we'll see what you get up to in the future.
@essentialhandyman2 жыл бұрын
Good luck with the move. I’ll have to send you a new sticker.
@WeekendShedHead2 жыл бұрын
Good luck! And looking forward to what’s to come 👍 cheers rob
@FamilyHomeProject2 жыл бұрын
Good luck with the move 🏠🏡
@LittleShedBigIdeas2 жыл бұрын
Thank you.
@maxgermasi33022 жыл бұрын
I believe this tool is a nothing more than a toy! I can not believe Bosch sells such a poor quality tools (I have several Bosch tools that last me a good decades) and they call it professional!!! Very disappointed!
@MrTommyt2342 жыл бұрын
Did you buy it or did you get it off ya wife for ya bday 🤣
@LittleShedBigIdeas2 жыл бұрын
Off the wife 🤫
@ralphharris63742 жыл бұрын
How much did that one cost? Looking at the website you’re looking at £1500 minimum
@LittleShedBigIdeas2 жыл бұрын
Hi, I think I paid about £1700. Two years later its still solid.