Remove your mirror and use an adapter plate suitable for the mount and g900. That way you can centre it better

Hey mate…. you’re dashcam is upside down 😅😅😅😅😂😂😂

Did you tighten the torsion based on pressure specs in tech stream?

Can you upgrade the 2.5k camera to a 4K. I found it straining the eyes to look at. the picture on the front camera is better

I’d still rather have a 25yr old 100 and keep on top of maintenance (=fixing stuff that’s broke) than own anything newer.

Do you have techstream? Setting the correct neutral pressures by cranking the torsion bars and changing the rear springs or adding coil spacers makes the ride and longevity of the spheres better.

What oil are you using on the AHC? I did a lift on mine but not all the way up. I can still all the L N H from the system. is yours dropping to low by pressing the button?

Me too - there are 7 in transit atm either from Japan or uae for my 105

Once it’s baselined and years of neglected maintenance has been caught up then you will have a reliable cruiser

That AHC lasted more than I expected. With that massive sensor lift.

Miss the Audi yet :p

Podaj numer tych części

Lol theyre all in Australia and expensive, as an Australian nothing truer has ever been said.

Actually it has 170degree cam if you see the play back you will see how wide it can record but the love view narrow and u can adjust it up and down ,if u connect the rear cam u there is split view for both front and rear and u will see how wide the angle it records I have one from another brands not wolf box but the same concept

Any update on this car

Any update on your golden car

Amazing channel

From Amayama?

Well if you drive on the proper side of the road this wouldn't be an issue.

I've got two. One for my truck and one for my wife's Challenger. Both work great.

Has it been a reliable vechile for you? Just bought one here in usa 100 series

Mate, always good to see another mighty 1Hdfte. Even if the Euro model has some ad on accessories. Worthy to note, if the rocker cover hasn’t been off for a while, it can be a bit of a pain. Make sure you get the very rear bolt out too, then a few taps with a dead blow hammer on all around the sides should break the seal. Valve clearances should be done every 10,000km best practise, but I have pushed mine out to 20, 000km without issue. Also, change the rocker cover gasket each time. The rubber compound breaks down over time and heat. Best cruiser ever! Cheers, Matt 03 Sahara Aust.

If you find a nut or a bolt on a Toyota that isn't 8,10,12,14,17,19,21,24mm you can almost guarantee that so one has been in there before you and changed some bits.

If you buy the oem style mounting kit it’s less that $20usd it will give you more adjustability since you’re removing the factory mirror

Best video i have seen yet

You should have bought the UK model for driving on the wrong side of the road/car😂

I feel your pain. Have you got any tips for someone who's finally got the same one, after being on back order for 6months. I had a quick look, and removed my old intercooler but couldn't see how it would fit so put it all back together to have a better look when the cars not in constant use {hence me buying this and a 3" exhaust in the middle of winter, when the car isn't used every day}. A lC specialist has told me you need to straighten the pipe coming off the bottom of the gearbox cooler and it should fit in front .I can't see it myself though. Did you use the supplied brackets? I wish you'd shown us all how to fit this, or not.

Thanks! My aerial on my 100 tries to go up - but as you say only manages a few inches. I couldn't even pull it up with force. So, ignition on - and then press aerial button? Cheers

Well, your steering wheel is on the wrong side!😂

I co pomogła ta modyfikacja

Nice 1 ill keep that in mind!

Great video!!!

Can’t beat genuine Toyota parts for tbat 100 series maybe you could get a recore Of that cooler otherwise I’d imagine it’s gonna be expensive lovely 100 series btw 👍👍

Holy hell! I was thinking about that product but decided to go with universal big cooler. Was very easy to install. Hope you get everything fixed.💪

I just replaced condenser and had it re gassed with dye, also had to degas it to remove rear aircon box to replace failed rear aircon fan and resistor .. fingers crossed all ok now

Deleted mine by bypassing the rear and joining the pipes so the front works. Common fault rear pipes corrode.

Your mirror is upside down.

Not a savage, a complete and utter Muppet. If it goes in, at some point you'll have to take it out. In seriousness though, sharing the failure so others don't make that mistake is great.

Thanks brother

Hi mate. It’s probably the most common mod here in Australia with a HDJ100 - to put a 3 inch exhaust on the car. It does help it breathe a bit better and gives a small improvment. Some keep the muffler, but some people just have a entire straight through exhaust - which is usually super loud.

Thread chaser?

Haha!!!

The bison gear side window panels for the Prado 120 are well designed so that I can still open the side windows

Mare that is so rusty , haven’t you heard of Lanox or WD40 that’s disgusting

This guy has no problem? Could you have used the pedestal mount? kzfaq.info/get/bejne/ndmEpLCD2pOtpKM.htmlfeature=shared I have ordered a wolf box. Will let you what happens

So I ended up buying and installing a G900 on my 2023 Volvo XC40 Recharge here in the US. So, driver on left side. I kind of had the same issue with where the front camera pointed. But there is a leap of faith moment you have to get to. Abandon the idea of using the mirror in "manual" mode. I use my rear facing camera exclusively now instead of just the glass mirror. I bought the G900 to use the rear camera to eliminate blind spots and it has worked wonders. What I ended up doing with the front facing camera was adjust the mirror so it had the correct field of view I was after. And ignoring that the mirror adjustment would no longer work manually since I use the rear cam all the time now anyways.

Honestly this is what i imagined when i thought the auto industry was moving forward.

zauważyłem, że masz jeszcze zawieszenie AHC, jestem ciekaw kiedy będziesz je wymieniał na standard + 2" , mi wyjęcie starego zawieszenia zajęło 2 dni

I removed my centre muffler, which had an amazing about of soot (no cats here in NZ for a ‘99 cruiser) and left the resonator at the back. Noticed the low down performance straight away and the sound is fine. Gives it a nice deep rumble.

Been considering a full turbo back 3inch system. Pretty much straight pipe but have no idea how loud that would be. Being a turbo shouldn't be deafening. Was considering a decat as a tester but thinking now you have bitten the bullet it's not worth it and may go down the full system route...the only question is to resonate or not to resonate