28 күн бұрын
4 ай бұрын
4 ай бұрын
4 ай бұрын
Жыл бұрын
Жыл бұрын
Жыл бұрын
Жыл бұрын
Жыл бұрын
Жыл бұрын
Жыл бұрын
Жыл бұрын
2 жыл бұрын
3 жыл бұрын
3 жыл бұрын
3 жыл бұрын
3 жыл бұрын
Пікірлер
@anthonya803 3 ай бұрын
What’s is the part number for these seals?
@bimmerphdmotorsports2226 3 ай бұрын
24 27 7 581 598 Adapter Grommets Set for Mechatronic Valve Body GM
@cameronscanlan1620 3 ай бұрын
This is the first video I've seen that includes removing the valve body and draining the tc. I'd like to see the whole process start to finish. I think for us non-mechanics working on stands in the garage, it really helps.
@bimmerphdmotorsports2226 3 ай бұрын
I'll see what I can do. How many more what to see a step by step vs just trusting your local BMW specialist ? give me a thumbs up here!
@bralewidowdan2987 3 ай бұрын
BMW MONEY PIT! Buy Japanese cars!
@karoly8556 3 ай бұрын
P r o m o S M
@JCArabit 3 ай бұрын
After every transmission fluid change should you reset the adaptation values and how do you go about resetting the transmission?
@bimmerphdmotorsports2226 3 ай бұрын
yes Absolutely. Adaptations are the learned algorithms your transmission has developed from your driving style. it is an adaptive system. Resetting them & re-learning or re-teaching adaptations is part of the service. That is what I've learned as a BMW factory technician over the past 20 years. Any shop that hands you the car & says go drive it....has not be taught the importance of following through to the end of the task. the adaptations on a GM transmission have to be taught by driving the vehicle in a certain process for the algorithm to learn proper shift points. A basic OBS scanner will not provide access to these files. We pay BMW annually to access rights to access diagnostic's & other information, its part of proving professional service.
@xsavier7984 5 ай бұрын
I have a problem with a humming noise in the car, I had the bridge checked, the parts were damaged, the shaft was also loose, the front bearings were also refurbished, it didn't help, maybe the xdrive was damaged, could it make humming noises?
@ikburd 4 ай бұрын
I have the same humming/buzzing sounds coming from my engine. I believe it's the boost solenoid. Common with the N54. Mines an N55. Rare, but they can fail. Having it diagnosed next week. Fortunately, it's a $100 piece from FCP Euro and an easy DIY from what I've seen on KZfaq. Hope it helps
@bimmerphdmotorsports2226 4 ай бұрын
Its Possible. Noises are difficult to isolate. A special NVH amplification tool is need to pin point. Don't hesitate to call us for a consultation.
@John-FourteenSix 5 ай бұрын
10K miles on these is way too early, unless the tyres have been running at the wrong pressure. 20K is easily achievable when they are inflated and maintained correctly.
@bimmerphdmotorsports2226 4 ай бұрын
John, I agree with you it possible. However experience has shown us MOST people do NOT check the tire pressures on their cars.
@docmopar426 7 ай бұрын
I do not see where to add fluid on the gm trans. I have a 2011 328i. It has a sticker on pan saying non servicable
@cameronscanlan1620 2 ай бұрын
There is a 17mm bolt on the side of the trans
@JPEAZI 8 ай бұрын
How do you take care of that transmission oil life code that remains despite clearing?
@Dom-gk9ku 7 ай бұрын
You can use ISTA to reset the oil life
@bimmerphdmotorsports2226 4 ай бұрын
Did you service the fluid before trying to clear the code?
@j.5akajohnny5 8 ай бұрын
With heavy mileage, and not having the luxury of the service history of the transmission itself etc, I’ve been told the using the vacuum is a no no, for you can suck out varnish and materials that actually are integral in the function of the transmission, and that the correct way would be the drain / fill / filter replacement, and then just cycle the fluid every 3 months to full get clean fluid circulating. What’s your take for I would like to service my transmission soon. Not sure which route to go etc.
@bimmerphdmotorsports2226 4 ай бұрын
@j.5akajohnny577 good question. For high mileage vehicle that have not been serviced to your knowledge. We recommend a complete fluid exchange. We use a special machine that will flush all the contaminated fluid out of the vehicle while filling the system with fresh fluid. You can actually see the progress and feel the result afterwards.
@leiflillandt1488 10 ай бұрын
Rule # 1: There must be no oil leaks underneath the car! If there are "small" leaks, keep a firm eye on them. They will not disappear by themselves! Be quite sure you know where the oil comes from! By the way a good, short video that shows that the owner has to keep an eye on the whole of his car, if he/she wants it to last a little longer.
@kalani1987 Жыл бұрын
What happens when the seals are not replaced?
@bimmerphdmotorsports2226 Жыл бұрын
If the seals are not replaced it could result in internal pressure loss & shifting issues/ We have seen the transmission malfunction light come on when the main adapter seal (made of plastic) breaks. Since the transmission operates of hydraulic pressure, it is very important to keep the fluid fresh & all the seals tight. We would be happy to answer any of your questions by phone or in person David. Thanks for inquiring.
@jongkeunlee Жыл бұрын
That's weird. I just replaced it and it fitted like a glove.
@dannyvien6329 Жыл бұрын
Where you located
@User37621 2 жыл бұрын
Awesome shop and techs. Keep the videos coming. 👍👍👍👍
@gixeronethou 3 жыл бұрын
Great Job!! It’s important to have that car inspected property on every time on every service. I’m sure your client is relieved and will surly feels the difference after the work you put into it.