No talking = 👎 If you wanna sell your product, you need to talk about it.
@sk13ppy4 ай бұрын
Craft smart talk in their videos, so why can't you?
@JSedits5896 ай бұрын
What type of resin is it? Epoxy or Polyurethane?
@ved-552210 ай бұрын
Good
@user-rs1990 Жыл бұрын
Is it possible to cast automotive light lenses using this kind of resin? 😕
@sebnemk2596 Жыл бұрын
Hi , is the objects can be paintable ?
@lyndah91852 жыл бұрын
My goto resin 😁
@morgancalvi66752 жыл бұрын
I understand this isn't real resin and it breaks easily...like if you go to use that board, it will break. Is that true?
@marikatalevska60792 жыл бұрын
Just like to leave feedback about your videos, how about you talk or leave notes on your screen. On how much casting you used etc. It will help beginners.
@protite_products2 жыл бұрын
Thanks Marika, your feedback is greatly appreciated. Each mould is different. We will be sharing a short video of how to measure how much casting resin for these moulds shortly. For this one it took about 90ml of clear casting which needs 30 drops of the Catalyst Hardener. We recommend that you check the mixing instruction below MIXING INSTRUCTION Wearing nitrile gloves and working in a well ventilated area, mix required amount of Catalyst and Resin. Recommended mix ratio at 25ºC is 10 drops of Catalyst to 30ml of Resin. a. Add 3 drops extra for each 5ºC decrease in temperature. b. Reduce by 3 drops for each 5ºC increase in temperature.*GUIDEONLY - FOR MORE INFORMATION VISIT WWW.PROTITE.COM.AU Not recommended for use below 10ºC. NOTE: Excess or over use of Catalyst will result in a shortened open time and Resin may cure too fast, overheat and crack.c. Mix thoroughly for a minimum of two minutes. Avoid entrapping air bubbles in the resin. Scrape sides and bottom of cup with stirring stick to ensure proper mixing of Resin and Catalyst.