Make your project easier , go to Harbor Freight and buy a blast cabinet and glass bead and clean your parts that way, it works great saves time and money in the long run + your buddies will probably pay you to clean their project parts as well. Your total cost will probably be less than $300 which you will spend anyway with other methods, sand paper & wire wheels have gotten really expensive& hopefully you already have an air compressor as you have already prepped your parts for paint by masking them off.
@justtellmethetruth73774 ай бұрын
I'll have to look into that, wire wheeling everything is a pain and messy as hell. I do have a compressor, been doing a combo right angle grinder, and standard grinder. This whole project has already cost me my right arm. Thanks for the info!
@GlobalWestSuspension4 ай бұрын
Thank you for your support and for the video! Enjoy your upgrades!
@danieldynarski76286 ай бұрын
my 2 cents....nice set up , but anti seize collects massive dirt...keep threads clean and when adjusting spray WD40 all over threads, and adjust. WD40 cleans off and dries nice. taught to me by major SCCA racer.
@MrBigal1231236 ай бұрын
that does not look like its gonna help with bump steer
@1966MustangRace6 ай бұрын
It's designed to help eliminate play, and correct suspension geometry on lowered Mustangs, which mine will be significantly and improve toe angle. This bump steer replacement specifically works with 65-66 spindle w/70 big pin which I upgraded to as well. But, I guess we'll see. Thanks and sorry took so long to reply, I'm new to this KZfaq deal.
@MrBigal1231236 ай бұрын
lowering the front of the car with the tie rod in stock position I found really helps maybe even better with this mod@@1966MustangRace
@williamdozier51907 ай бұрын
your sway bar link is backwards , the threads are suppose to be on top not through the U/C arm