You can try a reset on the overload sensor. Its a bit tricky, but a red light usually means its faulty. A green light when machine is going up

Quick question I’m checking a skyjack 4632 doesn’t travel up or down sounds like brake are engaged, when I press the brake release manifold it travels

Could be one of the forward valves getting hot maybe evn dirty. Have you try different speed when it happens. I know its an older comment but my notifications were off

Lol i guess I didnt think of that. Well I did but hopefully they're mature enough no NOT

How to get flash file

You would have to plug into the laptop and access all the information from the smart link

I know JLG usually tell you a code Genies do too but jlg seems a bit eaair as of getting codes

Not really with this issue, when you switch it do you get anything at all? Does the little green screen come up? The alarm maybe or does it not do anything at all?

@@avilaagustin1 Function switch on the joystick was bad. Found the same wire half broke all the way down. Changed the joystick. Back to working again.

Another issue with the genie scissor lifts are alot of dust or debri in the pump itself. If relay clicks and still doesnt move, open the side door where the hyd oil goes, and behind it you will see the pump, smack it while moving joystick and see what happens, also rn some compressed air in it. For some reason its really easy for it to stop it. Its well worth it

Its prolly a leaky hydrolic piston seal in the lift cylendar. I have leaky ones in my Kubota. Take the lift up put up the safety bar try and read the number on the cylendar collar. buy a new seal kit. To put it on takes about 2 hrs RnR, or take the cylendar into a parts house they can look at it and tell you which kit to buy. Its usually 3 O rings. Abt $13-23

Check your check valves for the cylinder thats leaking down. Safely remove the check valve, just make sure the machine is down. Then clean it real well and most of the time that fixes the issue, ir might just need a new one.