This video didn’t help with anything you just talks and didn’t show what to do

Is there another video that shows the actual replacement of the cable and how to pull off the old one

This was a total waste of time. It is a pin dummy not a bolt. You need to invest in a tripod to steady your camera.

Yea, why bother

Ok so you didn't show anything helpful..waist of time

could not figure out what and why you were doing what you were doing - it comes at a T- branch out, just disconnect the clamps.

Completely useless video. Very vague and you gave me motion sickness by waving the phone all around.

Remove valve cover, reservoir, ignition coil harness, engine harness clips and brake vac line from firewall. Slide clamp back, cut hose end, pull hose off. Replace new hose by hand, use very thin layer of rubber safe anti seize on the firewall nipples and attach premeasured pre-clamped hose and slide clamp back into position over the ridge. The tricky part is remembering which hose went to which nipple. So if you're doing both, mark them. lol

SHow how to get to the pump, what need to be taken out firts!?

I would be nice if you showed what hose you hooked you chain up to

BUDDY YOU AINT NO HELP (PERIOD) GRIND THE SIDES OF THE CABLE EYE DWN A LITTLE (OR) TGAKE A 3/8 BOLT AND MODIFY IT TO WORK GEEEEZZZ IT'S A NO BRAINER

Just remove 4 push pins from the bottom left, front-most splash guard & it's right behind there. Easy.

U need that pump outside it sounds like. Rain gna wash u out

What if the pump works but everytime you put fluid in it drains immediately? I’ve tried reconnect the black hose onto the bottom of the pump but I cannot keep it on

I just took mine out. Used a set of picks to break it loose. Do you remember which was the inlet and which was the outlet?

You skipped the important part-accessing the reservoir and pump.

What is the longer bolt part number? Please I need that number.

Pull the two bolts from plastic and wedge plastic then pull flat metal pin up. Run your wires away from pulley through plastic and connect to deck. Took me an hour.

Hey Lester is it the same for 2002 Malibu LS

Is it the same for 2018 Malibu LT?

Jesus... could you keep the camera still?? Got sea sick like crazy... and By the way: horrible tutorial.

0:44 sexygirls-here.online