21 күн бұрын
2 ай бұрын
3 ай бұрын
9 ай бұрын
10 ай бұрын
Пікірлер
@tacroom12 12 күн бұрын
Did you figure out what the part was that you found after removing the canister?
@Weezysfabandmechanical 12 күн бұрын
I did not. Thinkin some sort of check vavle for the vent. Truck is running good no issues so far.
@scottstevens1331 19 күн бұрын
Well done. Love honest people and you’re a wonderful guy pointing this out. My be reason I try to do most work myself as happened to me many years ago. Ended up 5.00 paint rebuild that didn’t even change the oil. 3500.00 plus he had to double it to stop me from calling police and during his shop. Money went to Africa to disabled people as cost 35.00 approx to keep them going a month. I wonder if he felt great doing so as I sure did. I bought used cheap car with decent small block installed it myself in a day drove that cruiser for another 200,000 kms. Was a fjcruiser with a replaced engine to chevy one of many I had. Drove them my entire life still do but a fjcruiser and as me rides nicer thanks again and well done!!!!
@Weezysfabandmechanical 12 күн бұрын
Appreciate it.
@IZeSerious Ай бұрын
Im trying to do this without dropping the tank. Heat sheild is blocking me from the front of the vapor cannister connections. Not using a lift either
@Weezysfabandmechanical Ай бұрын
It can be done without the lift just have to have a pretty empty tank undo the filler neck and just shift it around till it drops i dont remember how exactly i did it but you have to take the shield off
@danielb4375 Ай бұрын
What was the initial cause for needing to do a canister swap? I’m having an issue where my Laramie won’t except fuel.
@IZeSerious Ай бұрын
I'm having a same/similar issue. Took off vent hose made sure it wasn't clogged. Have trouble filling, only takes a few cents and then starts to overflow even tho it's near empty. Gas could be getting into my cannister at least. Trying to remove it and empty any gas in it and hoping to at least be able to fill up normally again
@Weezysfabandmechanical Ай бұрын
That is the issue it got to. Would not take fuel at the pump while running. And also i think it done it while shut off before i swapped it. But hard start after fueling up is a good sign with the not venting enough to pump at the station
@Weezysfabandmechanical Ай бұрын
Check your vent valve on the canister and the purge valve at the engine if those are being replaced and getting a code for check fuel cap go ahead and replace the canister. It will fix it atleast did for my wife's truck.
@youtubebannedme4207 3 ай бұрын
Redneck rig? I always heard it called something else.
@Weezysfabandmechanical 3 ай бұрын
Keepin it PG
@humbledhands 4 ай бұрын
Just the info I was looking for. BIG THANKS! I need to do some testing on canister to see if its reason tank not accepting gas. Got a decent smoke tester through Amazon to narrow things down. Glad to see tank drop not necessary for access to ports on canister. Also did a partial drop and partial bed lift on F250 fuel pump sender housing job. Did the swap fix the issues your lady was having with the vehicle?
@Weezysfabandmechanical 3 ай бұрын
It fixed my wife's trucks issue no more hard start. No more shuttin off the gas pump constantly. Its been runnin good so far.
@erniesoto7801 3 ай бұрын
@@Weezysfabandmechanical I have had the same issues. So was it just the vapor canister that fixed the issue or was it more? I replaced purge valve solenoid, leak detector. Imma bout to drop $300 on a new vapor canister and I wanted to make sure. Thanks for this video it was hard to find anything that would help me.
@Weezysfabandmechanical 2 ай бұрын
Yes it was the vapor canister causing the issue.
@illuminatiman 8 ай бұрын
do you sell the cars you restore?
@Weezysfabandmechanical 7 ай бұрын
Eventually i will have a few vehicles i will sell. Right now havent been doing any projects that have that in their future. Ive got a willys truck body swap comin, a ls swap into a project comin, and a cat diesel swap down the road.
@patriotridge 10 ай бұрын
Man, it's my dream to have a building like that.
@Weezysfabandmechanical 10 ай бұрын
Was mine too. Pulled the trigger and made it happen built it with my own hands.