ESL REPAIR / EIS REMOVAL PT 2
16:17
Ceramic coating my R32 GTR !
14:23
2 жыл бұрын
M.B ESL diagnostics / Repair.
19:58
2 жыл бұрын
Rx8 trunk panel Flocking / Suede  !
4:29
2JZ RX8 gets more boost !
5:03
2 жыл бұрын
Upgrading to AEM gauges on the GTR.
10:22
R32 GTR battery trunk relocation.
9:41
GTR gets a Gurney flap !
7:40
2 жыл бұрын
R32 GTR custom exhaust !
10:46
2 жыл бұрын
GTR engine blew up..
8:35
3 жыл бұрын
RB26 Turbos Rebuild !
12:29
3 жыл бұрын
RB26 GTR injectors rebuild.
5:43
3 жыл бұрын
Пікірлер
@JDM895
@JDM895 14 сағат бұрын
0:30 When rx8 turn in to r32 or r34 😂😂
@kweezo5273
@kweezo5273 Күн бұрын
Thank you soo much! I had the same P0462 fuel sensor code on my 2008 G35 and it caused the check engine light to come on . I was gonna replace the fuel pump and fuel sensor but I decided to replace the ac amp control module first before messing with the fuel pumps. So i bought a new ac amp control module from Infiniti and replaced the old one and my check engine light went off and it cleared the P0462 code I had for several months and the fuel gauge is working properly now. I’ll probably wait until I get another fuel sensor code to replace the fuel pump and fuel sensor. I have about 200k miles on my G
@1995naSTA
@1995naSTA 3 күн бұрын
Thanks for making this video. This was the only thing I looked at prior to R&Ring the rack in my X-Type and I had no issues.
@pjpokerpete
@pjpokerpete 4 күн бұрын
Ty so much ❤ 😊
@H00K-KING
@H00K-KING 4 күн бұрын
How much hp are they axles good for? How have they held up?
@user-2Hteyasizyc
@user-2Hteyasizyc 4 күн бұрын
I have read but lost the info in my service manual that the later or earlier models are wired to the ac auto amp but the other year g35s are NOT and they are wired from the fuel senders to the cluster itself directly. This can quickly rule out if its a cluster or ac auto amp issues. Can you or anyone please verify which years g35 had the ac auto amp wired to the circuit and which DIDNT? i really dont wanna have to pull out the ac auto amp AND the cluster if one doesnt work. Its enough work as is.
@CarlucciHS-v9r
@CarlucciHS-v9r 9 күн бұрын
Do I need a new ignition switch if the car doesn’t turn on once you replace the steering lock
@MuLife
@MuLife 9 күн бұрын
No. Contact me by email for details, [email protected]
@liamflynn6929
@liamflynn6929 10 күн бұрын
The brass ones I have seen are made for the 5 speeds only. They updated them later on to have 6 speed compatible collars, but I've never seen a video of one of these. Rmagic also makes a nylon one to essentially be an OEM replacement
@user-Alhassany
@user-Alhassany 10 күн бұрын
Thanks for the great detailed content Very helpful Is it safe to keep esl installed if it fails in the unlock position and after you program and install emulator or it has to come out ??
@MuLife
@MuLife 10 күн бұрын
Hello , your welcome. You have to make sure the ESL is completely unlocked and then unplug it. It can be left if so. Contact me by email for prices and details. [email protected]
@piolinov_iskandar
@piolinov_iskandar 14 күн бұрын
brother, i have question... Can i use oil pan RB26DET to RB25DET? Thanks
@antoine3355
@antoine3355 14 күн бұрын
Did you have to remove the starter and the slave cylinder for this?
@michaeljones22
@michaeljones22 18 күн бұрын
Thank you
@rudymans.1858
@rudymans.1858 18 күн бұрын
Thanks brother. I did initally replaced my passenger side fuel pump on my 2012 fx35 due to inaccurate fuel gauge issue I had. Also, because the car is old so I thought the fuel pump and levelling sensor showed some signs of malfunctioning. However, the the replacement, fuel gauge is the same. It doesnt go down past 3/4. Finally, CEL came on with this code. followed your tip and found one resistor with cracked solder. Resoldered it and now it's all good again. More power to you! God bless❤❤❤
@AlbertoSanchez-bp4wo
@AlbertoSanchez-bp4wo 23 күн бұрын
Great video! I am having the same issue with a 2012 SLK 350, can I used your Emulator to fix the problem. What is the best way to contact? Thank you 👍.
@MuLife
@MuLife 23 күн бұрын
Hello , Please contact me at [email protected]
@Chelseafanboy-wv9xq
@Chelseafanboy-wv9xq 28 күн бұрын
What material/adhesive did you use to seal back the housing?? I have the same issue it looks like and trying to gather info to work on it myself. Thanks!
@rngf_ashyxd860
@rngf_ashyxd860 29 күн бұрын
when I smack the top of the cluster the fuel level reads properly but not all the time could that rule out that the cluster is the problem?
@anabia8867
@anabia8867 Ай бұрын
very good bro ❤
@deonahaggard7174
@deonahaggard7174 Ай бұрын
Where’s the rest of the video?
@fierrosgaming
@fierrosgaming Ай бұрын
Hi i only had the code 85-01 i go stright to abs live data and shows in the solenoid valve (does not monitor) so what the mean is damaged?
@mega4507
@mega4507 Ай бұрын
was that a universal downpipe? if so what one
@MMMusicOfficial
@MMMusicOfficial Ай бұрын
If i manage to unlock the steering wheel. Do i leave the key in and remove the esl connector and module etc or do i unlock and then leave key in and disconnect battery?
@mistercatalus1783
@mistercatalus1783 Ай бұрын
Merci !
@hengkywijaya7253
@hengkywijaya7253 Ай бұрын
Hi man, if we change with chinese motor, does the motor will last like the original germany, let say like 10 years?
@MuLife
@MuLife Ай бұрын
No it will not , either bypass with an emulator or get a brand new ESL. do i once and do it right. contact me if you need an emulator at [email protected]
@alexibless3276
@alexibless3276 Ай бұрын
Since my ESL failed on April 5, 2023 until today 06/30/2023 I have seen and read all kinds of information on the internet about this problem and believe me when I tell you that this is the only video on the entire web which is professionally explained simple and coherent and straight to the point with no BS. My question is: How do I get an emulator from you, Sir?
@MuLife
@MuLife Ай бұрын
Thank you , you can contact me by email [email protected]
@alexibless3276
@alexibless3276 Ай бұрын
@@MuLife Ok I will right now. Thanks for the reply.
@jiabaohuang
@jiabaohuang Ай бұрын
Hi where is your shop? How can I contact you
@guerooo2042
@guerooo2042 Ай бұрын
Can a locksmith program a emulator?
@rexxor4219
@rexxor4219 2 ай бұрын
Hey, I have the same exact car and my ac compressor doesn't wanna turn on unless i use some bypass in the diagnostic mode, and i had a shop tell me its either my ac amplifier, or the low pressure switch on the condensor, have you ever had this issue or have any insight? It's either one of those causing my problem and not sure what's more likely. Thank you!!
@AJAL-og2ut
@AJAL-og2ut 2 ай бұрын
Hi, thank you for finding the solution that even the dealership have no idea how to fix this ugly Infiniti gas gauge problem. I would really appreciate it if you could help me with my issue after doing this repair. I have 09 G37x coupe, the only thing wasn’t working is the gas gauge, and the check engine was on for this issue only. Gas gauge was stuck all the way to full and never change. This morning I saw your video and I decided to give this a try. So I followed your steps and got the module out and went to an electronic repair shop and he soldered 4 resistors ( three of them marked (161) and one marked (181)) The guy soldered all 4 resistors and tested all of them and test passed. Went back to my car and installed the module and the gas gauge is fixed and no more check engine light. But Now I have multiple issues: the speed gauge is not working right and changes very slowly and doesn’t give you the right reading of your speed, also the rpm is doing the same thing, and I have the TPMS is on and the air bag warning is on. Thank you
@normandolinic2044
@normandolinic2044 2 ай бұрын
Why are they making cars harder to repair,more money at repair time???????
@user-ei5lg3mt7d
@user-ei5lg3mt7d 2 ай бұрын
How can I watch with that music grow up
@thilliuscrump3228
@thilliuscrump3228 2 ай бұрын
Can you please send me your number so I can send you my parts for you to program
@thilliuscrump3228
@thilliuscrump3228 2 ай бұрын
I have a e350 2013 with same problem I’m getting car back from Mercedes were do I send the emulator and key to program
@MuLife
@MuLife 2 ай бұрын
Contact me by email [email protected]
@thilliuscrump3228
@thilliuscrump3228 2 ай бұрын
Hey how can I send in my key so you can program it
@edwinotega5548
@edwinotega5548 2 ай бұрын
Boy you are good
@bgoodorhell4u
@bgoodorhell4u 2 ай бұрын
I have the same code on my 2003 maxima change the pump and sending unit still have the code.. does the 03 maxima have this module? And could this be the culprit for the code?
@altonlynch5464
@altonlynch5464 2 ай бұрын
Mine only gives one code, bad neutral safety switch. But is running in limp mode. It's a 1988 Ford F150
@michealdavies6259
@michealdavies6259 2 ай бұрын
What if none of the keys wakes cluster up and machine says key is good?
@etka
@etka 2 ай бұрын
hey bro my esl lock just failed in the unlocked position. i was wondering if i can just take out the plug to the esl and plug into the emulator without needing to take out the esl
@galaxiedance3135
@galaxiedance3135 2 ай бұрын
Great! Just the audio was kinda rough...
@user-nj7kp5wd6o
@user-nj7kp5wd6o 2 ай бұрын
Great solution My car 2010 glk 350 had same issue .and fix it my self absolutely same method . I did it . Thank you so much.no questions this video is perfect!!!!!
@Vgk36
@Vgk36 2 ай бұрын
Dude respect to you helping the g community keep these cars on the road man. New sub here for the simple fact that what you did here deserves a sub !!
@jozefpavlicek
@jozefpavlicek 2 ай бұрын
manual transmission cable, is it possible to adjust it somehow? Only when reversing does the lever go more to the back and then my reversing light does not come on. If I move it back, the light comes on.
@SV6SPD
@SV6SPD 2 ай бұрын
Where is this module located on a 2005 Infiniti G35 Coupe?
@Vgk36
@Vgk36 Ай бұрын
Did you find it ?
@sithakong1297
@sithakong1297 2 ай бұрын
Mercedes benz c220 cdi diesel w204 2010 has steering lock 2day how can I get emulator for them and how much t
@MuLife
@MuLife 2 ай бұрын
Check description for contact details. Send an email to [email protected]
@nguyenhainam07dc
@nguyenhainam07dc 3 ай бұрын
Could I just open it and use a griding machine to cut off the lock pin, ???
@kevinzametz244
@kevinzametz244 3 ай бұрын
Hello, I was just in a flash flood 3 weeks ago. Water did enter my intake but I can still turn engine by hand and all water was removed from engine and nothing entered cylinder area from what I can tell. I have replaced all can bus boards and replaced starter and still no crank no start and now have a parasitic drain in my battery any advice? This has caused me to loose my apartment as I am a Uber driver and can't work without my car please help any advice will help!
@cagarc01
@cagarc01 3 ай бұрын
Having this same issue but with no misfires
@lessthan0
@lessthan0 3 ай бұрын
Thanks. Trip to the Wreckers, a few dollars, And 15 minutes later my issue was resolved. You saved me hours and hundreds of dollars messing with fuel pumps and fuel level readers.
@MuLife
@MuLife 3 ай бұрын
Im glad this has helped you !
@adriantoma9031
@adriantoma9031 3 ай бұрын
The Best
@PontusThePilot
@PontusThePilot 3 ай бұрын
So mine just got really loud today but still disengages. Could there be some internal damage I should look at right away?