What's all this about chipbreakers? Bevel up planes do not have chipbreakers. If it did have one, it would be impossible to advance it any closer to the cutting edge than the length of the bevel, which would render it worthless in any case.
@MG-vo7is Жыл бұрын
Thank you.
@jeffstephens4163 Жыл бұрын
Great video
@Geekspeak1270 Жыл бұрын
Thanks, I have the exact one here, but it fell apart in my tool bag, its all better now! Thanks again!
@679inia62 жыл бұрын
Best explanation online 👏🏾
@richardcagle54752 жыл бұрын
Is the friggin blade supposed to sit at an angle out of the shoe? I'm new, but I can't imagine it's supposed to dig in on one side. I already spent like two hours flattening the base an another hour or so squaring the blade. The quality control on these things is straight shit
@yangkevin49652 жыл бұрын
try use it rather than talk it
@CandidZulu2 жыл бұрын
There is no chip breaker since the isron is bevel up. It does not need one. You can grind the bevel as you like, and the will prevent tear out.
@richardouzilleau31463 жыл бұрын
Qui traduit vos vidéo en français? C’est d’un ridicule incomparable....
@billdrumz93 жыл бұрын
A bevel up plane doesnt need à chip breaker, a bevel down plane has a chip breaker because the the back of the iron is flat. So a lever cap on a bevel up plane does not funtion as à chip breaker
@jeramyrocchi58163 жыл бұрын
spokeshave is a specific tool for the spoke of a wagon wheel to repeat the spokes uniformly
@nelsonsantos7703 жыл бұрын
How can I stop the refractory material from cracking?
@RafaelHe3 жыл бұрын
There's no chip breaker on this plane. The lever cap has no bearing in deflecting the wood shavings.
@mikecrawford53318 ай бұрын
I agree
@azzabouy82433 жыл бұрын
i agree the reassembly would have been nice but having bought this i still found it extremely helpful. thankyou
@jeetray113 жыл бұрын
seriously man - it doesn't look like you have used these tools enough to make an educational video. Thanks.
@olliemcdottie51254 жыл бұрын
This looks like a great video -- if only the audio didn't drop out after 10 seconds!
@nelsonanderson11664 жыл бұрын
No one cares
@Prfdt35 ай бұрын
Why be an a&& hole?
@short74404 жыл бұрын
If only I had half your skill...
@aliveandfit4 жыл бұрын
it would have been way cool to have included proper reassembly
@codyclark84054 жыл бұрын
Have u ever used a draw knife. It’s a nice vid but all u would have to do is turn your wood around and work with the grain
@theartof4604 жыл бұрын
Honestly used the spoke shave the most. For the others, one was given to me and I just ordered the other. I'll try to setup a better demo next time.
@christopherjames51925 жыл бұрын
Appreciate the info. I might have sharpened them for the demo but I get the gist! Thank you!
@theartof4604 жыл бұрын
Lol completely fair. Ill make sure to do alittle more prep next time!