It was for me, even though I crashed it :)

I got it from Hong Kong it's around 200 bucks

anytime bro!

thank you =)

for 6S gotta have at least 130amp 6S esc and around 900kv motor, for 12s, at least 130amp 12s esc and lower kv motor say 500kv.

thanks bro

It's really not a case of every copter doing it. I have 2 and neither of them did this. Just be careful to go over the copter before first flight like one would with any copter, perform calibration on level surface before each flight. Usually it requires some trimming after calibration during first flight so be ready for that, if starting out keep it in speed mode 1 initially. Also there is a youtuber named Andrej Sturm who shows how to do trimming and then saving the trims so you don't have to recalibrate everytime. He also shows his first flight where his does go straight up but he is fortunate there is no wind to make it drift away and he kept his cool and it came back down and didn't get damaged. This is why if a beginner I would do initial flights outdoors, zero wind, open area. If you have a good sized indoor space one could try it inside but the chance of running into hard objects and getting damage is higher especially for less experienced heli flyers. At least if it tryed to go straight up it would just run into the ceiling but if it did that I would just be ready or maybe have someone ready to like throw a rag at it to stop it from beating itself up if it wouldn't shut down. Mine have always shut down as commanded with the emergency stop button on transmitter. You have to push it and hold it down for a few seconds.

Not true. I have many of these C189 helis in different fuses. Out of the many only one has had the flyaway issue.

mine is so tamed.

I have two of um & they fly Wonderful 💯

thanks

Thank You!!