Пікірлер
@robertbritton9674 2 сағат бұрын
Not good
@ricoh1957 6 сағат бұрын
Thank you
@Jerry.V 21 сағат бұрын
quick question mate, so the power steering pump uses the same fluid as the abc suspension? or did i see that wrong?
@all-about-cars-basics 18 сағат бұрын
If by "the same fluid" you mean CHF11s then yes it does.
@KnowyourGadgets Күн бұрын
Wow, wow wow, forbidden iced coffee resurfaces again.
@scifithoughts3611 Күн бұрын
❤ this video is awesome. To learn how to undo the coil wires and coolant tube without making a mess, search for q5 spark plug change 2012 v6, AND coil wires Audi (the later video is short and demoed on a VW. Camera work is poor but watch through the end and you’ll get it.)
@all-about-cars-basics 17 сағат бұрын
Thank you for the compliment 🙏. And yes, the video you referred to is not very clear on how the removal process is done.
@mcdrone3932 Күн бұрын
The reason other videos suggest cutting the wires near the strut, is to attach the new connector to it, and use the old wire to pull the new wire through (instead of using a coat hanger).
@all-about-cars-basics Күн бұрын
Well, if you put it that way. That is another way of getting it done. Thank you for clarifying that.
@cartergift7128 Күн бұрын
😂😂 Good luck with that.
@all-about-cars-basics Күн бұрын
Let's hope so 🤞
@danielm94437 Күн бұрын
Forbidden iced coffee
@all-about-cars-basics Күн бұрын
Truely forbidden.
@DRNEGOLICIS Күн бұрын
Did it trash the engine?
@nusoftsystems7069 Күн бұрын
Lol, that never made it
@all-about-cars-basics Күн бұрын
We are yet to find out 🤞
@gabevalencia953 Күн бұрын
Does the car have to be in neutral for this or can it be in park
@all-about-cars-basics Күн бұрын
Yes, putting it in neutral will help you to turn the shaft with ease while removing the bolts.
@CL500MBZ Күн бұрын
What you need to do is always buy a locking gas cap before you cheat on her.. much cheaper
@all-about-cars-basics Күн бұрын
😂😂 Yes.
@CL500MBZ Күн бұрын
Those are glass headlights.. use windex next time. It's easier
@all-about-cars-basics Күн бұрын
Lol, Windex always does a great job. For the case of the Mercedes W203 models like the one in the video, it came with plastic headlight lens installed instead of the glass lens previously used in the prior generations.
@CL500MBZ Күн бұрын
Great video. Might as well do a full coolant flush and hydro fluid flush. Best to remove pully bolts before the belt
@all-about-cars-basics Күн бұрын
Yes, that is a great idea 👍. Thank you for taking the time to leave a reply. I appreciate that a lot. 🙏🙏
@Henrymichaelball 2 күн бұрын
No you don’t have to let the Freon out. I put a tiny bend in the Low pressure tube to access one 10 mm Valve cover bolt. Removing intake also not needed. Just need an injector puller. Can get from Amazon.
@ArjunSumman-fv5kh 2 күн бұрын
Thanks for helping ❤️
@all-about-cars-basics 2 күн бұрын
Any time.
@Grrrnthumb 3 күн бұрын
Thanks for the tip!
@all-about-cars-basics 3 күн бұрын
You welcome
@ByMyRecords 4 күн бұрын
Broooo this is the best video on how to do this from the top
@all-about-cars-basics 3 күн бұрын
Thank you.
@barrywilmeth3554 4 күн бұрын
my 2013 does NOT have a reset button. I have looked everywhere.
@barrywilmeth3554 4 күн бұрын
I finally found it on my 2013, it is not directly visible but if you put your finger to the left of that inside screw you will find it.
@all-about-cars-basics 3 күн бұрын
@@barrywilmeth3554 Awesome. Did you succeed in resetting it?
@barrywilmeth3554 3 күн бұрын
@@all-about-cars-basics Yes. I was surprised but it did reset. Thank You.
@all-about-cars-basics 3 күн бұрын
@@barrywilmeth3554 👍👍
@karolsanchez7841 5 күн бұрын
What about micro glass from leather seat? I tried vacuum and wipes, but still feel like little pieces are in the seat 🥲
@all-about-cars-basics 4 күн бұрын
Try using a potato or a lint roller or a duct tape. Those usually work for me.
@IsaiahFrosh-ch2jl 5 күн бұрын
About how many liters of oil does this gear box takes
@all-about-cars-basics 5 күн бұрын
I hope you mean transmission fluid? if so, it usually depends, full flash will require 10.2 quarts, but a regular service will require around 5 or 6 quarts. A quart is almost the same size as a liter so it will be 5-6 liters.
@Smudg 5 күн бұрын
I was wondering if you could help me out here, I have a 2008 ML350, while taking out the radiator, I mistakenly pulled the AC line from the Radiator side, Freon vented out in the garage and it was not a comfortable moment. I have since not driven my car or even turned the key, it stayed in the garage but did not cover the pulled line but it stayed in the engine bay. The Compressor hoses are still connected. I am worried if I need a flush? A new condenser? Or put the hose back and go to a garage and have it recharged? Thanks for helping out.
@all-about-cars-basics 5 күн бұрын
Sorry to hear about that. First, there is a connection between the line going to the compressor and the condenser, it is usually connected by 10mm bolt or nut (this connection point is usually next to the radiator on the side). Is the pulled line past that connection or before towards the compressor?
@Smudg 5 күн бұрын
@@all-about-cars-basics Pulled from the radiator side. both lines on the compressor ar still connected.
@all-about-cars-basics 4 күн бұрын
@@Smudg Then you will need to replace the condenser, before you go for the recharge
@Smudg 4 күн бұрын
@@all-about-cars-basics Thank you.
@MichaelFucciani 5 күн бұрын
Great video, wish I had seen it before I paid $3000 to get mine replaced about 7 months ago!
@all-about-cars-basics 5 күн бұрын
Dang! that is so unfortunate. Anyways, it can still be of help in the future. Thank you for taking your time to watch the video and leaving a comment, I appreciate that.
@genegvahle23 6 күн бұрын
Shocks were replaced years ago . Just removed suspension pump. Smaller hands are helpful. I removed radiator hose , used boat oil change pump , suck out fluids. Not to messy 😊 73 years old .
@all-about-cars-basics 5 күн бұрын
👏👏 Well done. That is incredible.
@Katie-xn9je 6 күн бұрын
Does the person replacing the glass vacuum the glass out of the car?
@all-about-cars-basics 6 күн бұрын
They should.
@tisacaruso9010 6 күн бұрын
Thank you!
@all-about-cars-basics 6 күн бұрын
I appreciate that 🙏.
@roadadventurer4836 6 күн бұрын
Nasty!
@followerofyeshua7307 7 күн бұрын
The real question is why does the engine oil look like it hasn't been changed in over a year 😮
@karlgould7092 8 күн бұрын
Engine oil? Looks like dirty river water
@user-ok7vg6bt4g 8 күн бұрын
Perfect! The right way in good detail!
@all-about-cars-basics 8 күн бұрын
Thank you. 🙏
@queef_sniffer3000 8 күн бұрын
That's not a strut lmfao
@TheChronicles-id5qz 8 күн бұрын
😆 breh, you never heard of hood struts?
@all-about-cars-basics 8 күн бұрын
My bad, I just mentioned struts without the hood part on it. They come in many different names. hood struts, prop rods or hood lift support but they mean the same thing.
@user-lb4wf1jm8o 8 күн бұрын
2 struts much value
@all-about-cars-basics 8 күн бұрын
😅😅 yes.
@kylepintor5830 8 күн бұрын
Chocolate milk oil no bueno
@all-about-cars-basics 8 күн бұрын
Si.
@AMScotty 9 күн бұрын
Nice try. You can't use chocolate milk for engine oil!
@all-about-cars-basics 8 күн бұрын
😅😅
@thomas1055213 9 күн бұрын
Sometimes engines aren’t designed for every car they’re put into, sometimes shitty engineering is the result of a tight budget or parts bin building by manufacturers
@jonhaze7537 9 күн бұрын
Thats not oil, thats chocolate milk!
@jaksngreen 9 күн бұрын
Looks like crap o chino
@braydenjohnson5880 9 күн бұрын
Why are you changing it? Oil looks brand new
@johngalt2508 9 күн бұрын
One word.. Fumoto
@johngalt2508 9 күн бұрын
After getting further in...never mind wasting money on a fumoto for that thing😢
@all-about-cars-basics 9 күн бұрын
@@johngalt2508 😆😆 right.
@curtisflowers2733 9 күн бұрын
That’s oily coolant
@Bretware904 9 күн бұрын
This is why engineers hate everyone
@Scratchingforcash 9 күн бұрын
It’s called a “self lubricating system”
@all-about-cars-basics 9 күн бұрын
😄😄
@AJ-yo7rb 9 күн бұрын
Sometimes the engineers have to put engines in 6 different cars and they have to compromise, the Holden ve commodore has the thermostat nearly in the transmission tunnel, requires to drop the engine out to change a common part
@all-about-cars-basics 9 күн бұрын
Regardless, they are engineers for a reason, not some lousy roadside mechanic on training 😂. It is not rocket science to change the drain plug to face the ground instead of sideways.
@keirmalnack8580 9 күн бұрын
Might have Been able to get away with a funnel
@all-about-cars-basics 9 күн бұрын
Totally avoidable if the drain plug was placed to face the ground instead of sideways.
@keirmalnack8580 9 күн бұрын
@@all-about-cars-basics always true
@computersales 9 күн бұрын
They didn't want the frame to rust. 😂
@all-about-cars-basics 9 күн бұрын
😂😂
@1FeistyKitty 10 күн бұрын
bfd --- that's what rags and simple green are for
@michaelmagee2062 10 күн бұрын
Oil? You mean mud?
@all-about-cars-basics 9 күн бұрын
😂
@brettphillips9652 10 күн бұрын
Forget the engineer let's talk about the color of that oil lol😂😂😂😂😂😂😂
@zachmadonnawesberry3258 10 күн бұрын
That car is taking a shit
@all-about-cars-basics 9 күн бұрын
😂😂
@Zer0SeverSky 10 күн бұрын
Damn that’s chocolate milk
@Mumblix 10 күн бұрын
The engineer has stock in the Fumoto Valve company.
@all-about-cars-basics 9 күн бұрын
😂😂 Yes, most definitely.