Good sound quality

May not be the best thing to walk into in the morning, but a SIMILAR thing happened with me!! I was at home, not too far off from my first school when I heard this EXACT tone! It was muffled, and i couldn't find out the direction of which it was coming from. I went outside, and sure enough, the school was emitting that tone. So, I assumed the obvious and ran over to the school, and sure enough, an appliance was already sitting at the front parking lot with 2+ members inside. I walked closer, tone getting louder, and noted that, in fact, the school was in emergency. The Pertronic F16 stated that it was coming from the 7th zone, first floor, middle classroom. Ran towards, met the new Notifier SPH-15 horn that'd been just installed, and GOD was it loud! I ran to the alarmed class and noticed no active device.. so, i kept being the detective I am, and looked above the exterior veranda.. and sure enough, a defective Pertronic indicating heat was in alarm. Alarm was silenced, appliance left, and realized that the F16 said "defect"! The detector was falling off the roof, probably weathered, causing the alarm. The system is monitored by FENZ. Should be replaced soon.. totally an AWESOME experience though!

That is really scary

Cause was a smoke detector that had gone off after dust from an air conditioner that hadn’t been turned on in a while was blown into the detector.

AviaVOX

those can be replace it

Hello, is there like a marketplace where people get their alarms? I've tried trademe and facebook marketplace, but I haven't seen any in a while.

Nice one!

Bro you will get fired from you job don’t do it💀💀

Great video, I love to see fellow nz enthusiasts!! Hopefully I can get a panel soon

Is there a way I can do that with the speaker and a call point with no fire panel

Amazing, how do you setup a very simple one at home without a panel

Awesome test. Dont usually see Nz's enthusiasts test these kinds of things every now and then.

General question. I am setting up an f16e demo and became stuck. Unlike my f4, the f16e doesn't go into alarm on an open circuit in the zones like the f4 can. This means my older switch based call-points don't work and just create an open circuit defect. I don't have any powered detectors to test but I assume they would work. Is it a thing that can be configured? Thanks for reading and I am happy to see a video! Keep it up!

I have been to New Zealand, and they have Fire Siren in The Fire Department. And i heard it going off it sounded really cool

It’s happens on all Dsc systems where it goes in stay mode if you type in the code but beeps like it’s going into away mode. You just gotta press the actual away button in order to fully arm it into away mode

This is Cool!

Nice vids. Do you by any chance have videos of the red siren they used to have in schools here in nz

Man I wish uk alarms where like us

*Promo sm* 😳

I need one to buy to use if there's a fire cool as i love alarms and I like the videos you make

Hi are you in nz

How'd you do that?!

thats a cool way to use an old speaker

Pretty cool your in Whanganui, I know the site your at!

Thats awesome bro, any tips on getting my hands on fire alsrm equipment in nz?

Hey bro that mcp your unsure of is a carrel &carrel mcp as far as I could find is carrel & cartel rectangular mcp but I’m sure it would have to have a proper name they are no longer made but the switches on them seem to be different on a lot of them some having a pertronic like switch style then the one you’ve gots style and then some weird switch on some. Will do some more research and try to find out more

Vigilant Alpha 1 system. Single-zone. These systems I have not seen in New Zealand. Specifically Christchurch, where I am based. I tend to see others, such as the MX1, FP1600, and whatnot, but I have never actually found an Alpha. I prefer these panels over the F1 due to design. I like the Alpha design - it's good. Using nice Series 130 call points by Vigilant, installed by Wormald, I am to assume the system is also maintained by them? Anwyay, the alarm of choice is off. Ampac (Klaxon) sounders with PS1 red sounders. If the PS1s need an amplifier, which I'm sure they do, why not put more around the premises instead of Ampac sounders? Also, how'd you get that Ampac tone? Was it selectable on the Pertronic EVAC50W24V amplifier or any other one you used?

Wow in the uk only 2 MCPS and no detectors would not pass so diffrent in NZ loving it

n the battories take a multy meter to em and test em if there around the same it says it is in the battories there fine.

Nice looking F220 from Pertronic! I'm going to have a Vigilant MX1 for my setup.

great vid subbed btw

Cool video!!!

I know it's not required for New Zealand, but would you consider installing some strobes?

Nice system! Pretty excited to see what you have planned for it.

Wow, very, very neat system. I love it!

Awesome video! guess you beat me to the F220a lol! that dinner bell is a pretty neat touch. are you using the external amplifier because of the pre amps low audio quality?

Looks exciting!

Quite neat! I think that was too much smoke!

too much smoke lol

Another thing is your panels are probably one of the best panels because they have built-in voice Evec here in the US voice Evec would cost you around $2000-$3000 depending on what panel you’re getting and most of our panels are very proprietary. Meaning you need a computer to program them for example Est 3 is extremely proprietary You can’t do anything with that panel without the software.

I’m commenting from the US what do you call that type of wiring? Do you call it in nz class a oh, what do you call that type of wiring cause here in the US that switch you were wiring here in the US we call that a class a loop what do you call it?

Did bro just wire up his house with the F100a?!

I think that Vigilant MX1 panels can great for gas extinguishing systems for machines (such as diggers, cranes, dump trucks, trains, boats and other types of machinery).

Your system and collection is awesome what websites to you get them from!

Let’s get in touch I would be interested in the code as I know somewhere that would be useful

Oh, that’s sick!