Garbage. Buy metal and pay 10x less over its lifetime.
@Erica-mf6vnАй бұрын
seek cooperation
@Erica-mf6vnАй бұрын
seek cooperation
@bahmanshabani76952 ай бұрын
Good job
@fabYOUluhslife2 ай бұрын
Very informative thank you
@sarahschmidt41773 ай бұрын
We have an Ondura roof on our porch which is getting worn (it is 21 years old). Question: Can we leave the Ondura roof and cover it with a metal roof or must we first remove the Ondura roof? Thanks!
@NTSRFR43 ай бұрын
What is the advantage of using this material?
@ibrahimkc26456 ай бұрын
Where in Kerala
@pat.traynor9 ай бұрын
I just finished installing an Ondura roof onto my new firewood shed. It was very easy, thanks to your video! Why do you screw into the peaks rather than the valleys?
@dluxsolutionsathome51629 ай бұрын
The valley will create a leak entry
@robcamfield9 ай бұрын
where do we get those please?
@kunjoonj110 ай бұрын
Awesome, thanks great work.
@Shandchem11 ай бұрын
Guidance and tips very much appreciated! Thank you!
@alexconcord359711 ай бұрын
Thanks for all the hints.
@h.b202911 ай бұрын
Excellent. Very helpful. Thanks. God bless.
@mindrenewal765711 ай бұрын
Very helpful. Tips very helpful. Thanks for your patience and video
@richardmoffatt6606 Жыл бұрын
You're awesome thanks for the time invested in making this video !
@richardmoffatt6606 Жыл бұрын
For using this product on an older garage, should I put a small bead of silicone on the overlapping seams? Would that help prevent rain or moisture blowing up underneath and wetting the roof? I'll have to put down the black tar paper over the roof once I remove the shingles, but when I hammer down the corrugated roofing, wont drops of rain seep through and into the roof itself? Should there be anything else added to prevent any moisture from accessing the inside of the garage?
@ilanmagen Жыл бұрын
No more Gray panels 🤥
@pingpingchan4197 Жыл бұрын
加一层然后搭配屋顶不銹钢板包边十螺旋钢釘🌟✨🔰
@Weider.Lizama Жыл бұрын
Hi thanks for the video, Is this product good or should I say good for those states that we get snow????? ❄️
@tommybroughton2191 Жыл бұрын
how much do these panels stretch I have a 52" long roof on a chicken coop I'm building and want to try to do this with one 48" wide panel cut in half
@ss_whole Жыл бұрын
Those foam closure strip are not going to be water tight, they have holes in them.
@deanabossio3091 Жыл бұрын
I'd like to use them on a metal-framed chicken run. It is possible? It seems would have to add some support to the frame to support the panels.
@elwoodanderson4149 Жыл бұрын
How would I attach Ondura to vinyl siding like adding on a porch
@rerspss Жыл бұрын
Horror!
@EHCBunny4real Жыл бұрын
Can I use Ondura roof panels as privacy fencing?
@mattfowler9304 Жыл бұрын
I havnt installed Ondura panels in a few years and needed a refresher course for a small project im doing in the morning. So i started watching your video and quickly realized it was the same video i watched 3 years ago haha. You are a natural instructor. Im a 3rd gen carpenter and you tell us things in this video that the common man wouldnt even know he needed to know. Thanks again for the great video👍.
@StrayedIdea Жыл бұрын
Yeah this guy knows how to reach out to peasants like myself.
@hoots022 жыл бұрын
Would you use this on metal framed gazebo?
@freshofbreathair14762 жыл бұрын
Can I use 2” roofing screws (with neoprene washer) for this product? The store that sells the panels never has the nails in stock and they are overpriced anyway.
@MeWash732 жыл бұрын
Super! Pomogłeś chłopie.
@sgtrutters58922 жыл бұрын
Exactly what I needed to know to put some roofing on a woodshed I just built! Everything else I found was either doing a roof with two sides or one attached to a house. I wasn't sure how to seal the end, but bending over the bridge cap should do it!
@magnang2 жыл бұрын
What's the minimum pitch for ondura? I see the front of your building looks to be around 1/12 ish? I am looking to use this on a 1/12 carport, with a full deck. Would it work? I see onduline europe has instructions for overlapping 2 corregations on lower pitch roofs. Can ondura do this also?
@martinchampagne33402 жыл бұрын
En francaus s v p
@bethanycolonnese93012 жыл бұрын
He states to use at least a 1/2 plywood but with those screws that he shows (3 inch) they will stick into the top of the house by about 1/2 inch. Am I missing something? I am building cat houses so I can't have 1/2 sharp nails sticking out.
@Jspifferman2 жыл бұрын
Can it be added over shingles?
@passiton38012 жыл бұрын
Excellent, well informed, instructional video, with lots of helpful tips!
@jackofmosttrades91272 жыл бұрын
Hard to tell which side is up. And tips on this? Both sides are brown on mine.
@ndizzle8069 Жыл бұрын
Mine just got delivered and I was thinking the same thing.....I noticed when he was installing it, he had the side facing up that had the barcode sticker on it 🤷🏻♂️
@wirutps3332 жыл бұрын
Beautiful, which country?
@lukewang43962 жыл бұрын
Great video! Thanks
@learnjcbskidsterchickensga75942 жыл бұрын
I just tore two (15? Years old in Illinois) roofs of this stuff….using steel this time.
@TheReviewPigeon3 жыл бұрын
very straightforward and helpful for all corrugated roofing.
@demesrvl67613 жыл бұрын
Totally bummed; it's only available in four dark colors now; green, brownish red, brown, and black. Would have loved grey, which looks a lot like galvanized metal.
@TheArgentlion3 жыл бұрын
Thanks this was very helpful!
@ekurdesov3 жыл бұрын
how long do those last?
@donalddoty5768 Жыл бұрын
My patio roof lasted 18 years and I then coated it with elastomeric paint. Good for another 10 years I hope.
@vickieanderson62553 жыл бұрын
Thank you so much for your instruction and also for the accompanying tips--GREAT VIDEO!
@MarcSa3 жыл бұрын
👍👍👍
@bjmurr63093 жыл бұрын
Excellent video!
@joncamp42533 жыл бұрын
Amazing, straightforward and clear instructions. Thanks!
@sillysunday70653 жыл бұрын
This is one of the instruction videos I have ever seen. Answered all the questions I have about installation. Has convinced me to use them on a small shed I am building for an automower.
@ruderussian98113 жыл бұрын
Do the bees going through those holes in that rubber? Thanks for the video!