@@czkarting yes fast but a bad finish, I use the pomp because here we have very hot temps +37°C and water have +28°C

Nice setup! The boat runs very loose,and fast 👍. Nice prop sound too 😎

​@@CozyRC Yes but not fast enough 🤭,I don't know what else to try to beat my PB🤔I'm already on a knife edge with setting up the boat🫣 Thank you for your support every time🙏

​@daiciuapostol79 You could try a shorter rudder blade, for less resistance

@@CozyRC I don't whant to cut this one🥺

​@daiciuapostol79 make a new one!

for me it's hard to tell the difference just from the sound of the engine, yes a propeller for hydro I think than for a vhull, it cavitates a lot when starting but when it gets up everything is ok except for the jumps that were due to the small waves created from the previous passage it seems that with this propeller it is very sensitive to these waves, but it seems promising at least on 4s with 6s to much lift maybe different setup on stinger

​@@daiciuapostol79 The rpm seems to drop a lot from cavitating to 'grip'. In combination with your comment that it already destroyed esc's and a motor, I wouldn't use that prop on a V-hull. Only very light running hulls, who can take the prop load. What was the speed on 4S?

@@CozyRC 98 km/h with 6 mm less prop, I have +3mm stinger setup

@daiciuapostol79 not bad, with 2000kV motor?

​@@CozyRC thanks ,no same TP 2350 Kv my all time PB on 4s it's 106 2 weeks ago

@@FEboats thank you, good luck

@@FEboats Thanks, yes everything it's build by me only the electronic it's not

@@daiciuapostol79 that’s great! It’s running well. What country is that?

@@daiciuapostol79 I’m in USA California but my family is from southern Italy 🇮🇹

@@peteroosterhoff8850 yes it's fast and stable with this big prop but to hot esc and motor maybe a lower kv whit high voltage will help

@@daiciuapostol79 48 hi rake i never tried, but know they need more amps from my smaller props. Possibly a bigger esc drops temps bit, but its still a high kv motor that probably runs near its limits so it will run high temps no matter what. The speed your running now is really good on 6s in my opinion...

@@peteroosterhoff8850 I whant +135 km/h.from this setup but the boat still not set perfectly,wether hear is so hot water have already +28°C In the morning not best for Speedruns

@@daiciuapostol79 wow. Were having around 28'c air temp today. Water don't know, but i guess its maybe like 16 or so since these are the first decent summer days.... And i have no boat to run since i was working on it and have no spare time at the moment... 😢

@@peteroosterhoff8850 sorry for that, air temp +40 from one week already heer

@@RCplamodel thank you for watching 🙏

Yes sir,and every time change something you need to start from zero and find again that right setup,but this is amazing at this hobby 😊

Yes no PB today,4s 105.106.101 km/h and on 6s the prop it is to much 124. 125. 126 km/h and yes afther the first pass I saw the power and I didn't open full on second and third one

Oooooo thank you sir🙏 long time no see We need some off you runs here🤗

Indeed. Hope to return soon enough🚤

Thank you 😊 Batteries 1cm in front and trimtabs 1mm up stinger the same -2mm and this time straight rudder blade

Yes it's run so different Thanks

Thanks,I will check if something wrong in the driveline but I think it's just the sound of a wood boat with a big prop

@@daiciuapostol79 Well, noticed its sounds "rough"... Maybe its nothing or it's just the combination with the big prop or some rust or something...

@@peteroosterhoff8850 I clean afther every run with WD40 the flexshaft and grease

Thank you

On this run I have 3s 6000/70C +2s 5000/70 C in series for both ESC

This is the only twin props that I have,thanks for advise

Thanks🤗it was just a test to see how to setup the boat for this prop,let's see how fast can go with the right setup

Yes first time ,different props needs different setup so next time maybe will run much stable

Yes the octura it's very different from ABC so I need to find the best setup,I think she can do more with this prop Thanks for watching 🙏

@@daiciuapostol79 yes Octura props are very good but be careful whenever you balance Polish and sharpen they have beryllium in them always wear a mask

@@KevinTodd yes I know that thank you for remind me 👍

kzfaq.info/get/bejne/abeAdbJ6ss3Sdn0.htmlsi=7WXdWVWLtn2hjyC1 🙏

Thanks🤗yes they are strong

2 hours🫣

@@daiciuapostol79 maybe a sup for such a big lake..? Saves a lot off time i guess... 😄

Yes is bad when happened. The propeller was second hand from ebay Germany one blade was quite damaged, I really spent a few hours rebuilding the propeller it was quite difficult to work with the titanium propeller.

Yes 8 from 10😁

Thank you, yes a very good hull and the only twin Veles😊

indeed it is very hard to wait it tries you all kinds of feelings🥺

That's a lot of time and distance! 😳 Once I spend over a hour for almost fully submerged Key Biscayne..... It moved slowly with wind and waves almost 1 kilometer.

@@czkarting because of the shaft lost the water come inside from stinger and was half with water so very very low speed on this "pass"

O that's nice good luck, what motors and esc's,props?if I can ask

@@daiciuapostol79 2xseaking 180A, Leo 4074 2650KV on X447 or H1717

@@BrainlessBad hot setup(SAW boat) disable LVC if they are V3 version,I whill like to see some runs with the boat😊

it rolled a few times, probably the engine support also helped with the correct landing, which brings the boat a very low center of gravity🥰, I don't have a recovery boat, in the past I used the rigger to push overturned boats, I usually swim if I don't have a signal, or just and I simply control the overturned boat from the remote control, it takes longer but I manage to bring it to shore

​@daiciuapostol79 Ah, I see. When the boat still works, the prop acts as an air propeller, pushing the boat forward. Most of my boats run pretty good upside down 😅. But when the boat breaks down, a recovery boat is really convenient. I got on old ECO boat with a pool noodle at the front. It works, but not great. I'm thinking on making a recovery boat from pool noodle and an airplane prop for thrust.

@@CozyRC yes I so you recovery boat on pictures on forum😉

Thanks

I really appreciate sir,the ztw have a soft start, I whill try my best

Yes very early in the morning for that,hope you had a great day boathing, thanks fast and stable😊

Yes, it were good. Not that fast as yours, but I also didn't wreck anything....that's counting too😇🤣

Thank you Cozy

Yes, the title is confusing, I'm trying to break the 100 km/h barrier in 4s again my best was 105 but the 2s batteries start to get old ,uploading the 6s run as we talk😊

@daiciuapostol79 New, high capacity and high C-rating batteries can make a big difference 👍 I'm going to watch your 6S run now 😎

​@@CozyRCyes,I miss my sls speed edition 4s lipo

🫡🙏

Thank you 🙏Emil

Thanks 🙏

Thank you Cozy for watching 🙏 all 16 min I know it's hard whit all that screwing unscrewing🤭 and taping, yes I didn't made long pass how I do usually because the water was full of big and small sticks,that whill be amazing again 130,but I'm very happy how the boat run whit the new rudder and stinger that is so amazing for me my friend. Did you run your G-Force on the event?

@@daiciuapostol79 Yes, I did. But it was just too windy, resulting in rough water. I made 2 runs, but the second run I broke my rudder bracket. I can still fix it I think. I also started the Wildthing restoration. Hopefully later this season I can run it again 😎👍

@@CozyRC do a "T" support for the rudder and much more robust to hold on the power of G-Force, nice Wildthing on road again🥰

@daiciuapostol79 The bracket didn't break at the base, but at the hinge point. The holes holding the hinge shaft broke open. The construction was too thin at that point.

@@CozyRC O I see,anyway build a strong one🫡